SECTION 5—WHEELCHAIR OPERATION
MPJ+ Joystick Switches and Indicators
NOTE: For this procedure, refer to FIGURE 5.3.
Drive Select Toggle Switch
The drive select toggle switch is located on the left side, below the LCD. The drive select position is momentary, meaning that it will return to the neutral position after a selection is made.
This switch allows the operator to select the type of operation or performance which best suits a particular control need or situation. The DRIVE 1 program uses performance values which are independent of those used for the DRIVE 2 or 3 or 4 program. As an example, an operator may have a control need for spasticity in the morning and a very different need in the afternoon. DRIVE 1 can be programmed for higher speeds and quicker response while DRIVE 2 can be programmed for slower speeds and less responsiveness or vise versa. The other two drive programs could be indoor and outdoor versions of DRIVE 1 and DRIVE 2.
Selecting the Drive Mode
1.Move the toggle up and release. DRIVE 1 (
) will appear on LCD.
2.Move the toggle up and release again. DRIVE 2 ( 
) will appear on LCD.
3.Move the toggle up and release again. DRIVE 3 ( 
) will appear on LCD.
4.Move the toggle up and release again. DRIVE 4 (
) will appear on LCD.
5.Move the toggle up and release one more time to select DRIVE 1 (
).
Charger/Programming Input | Memory Card Slot |
| |
(Front of Joystick) | LCD Display |
| |
| Mode Switch |
Drive Select Toggle Switch | Speed Control Knob |
Programmable Joystick
Mono Port 1/2 or
Remote
External Mode
On/Off
Switch
Input
To Controller
FIGURE 5.3 MPJ+ Joystick Switches and Indicators
Speed Control
The speed control knob is located on the side of the joystick housing.
1.Rotate the knob clockwise (forward) to increase the speed of the wheelchair to the programmed max speed.
Formula™ Powered Seating | 28 | Part No 1122170 |
