Cleaning the Steam Wand and Frothing Attachment

PAC geRE header& CLEANING.....

Concentrated Solution (for harder water)

•1 part white vinegar

•1 part cold tap water

WARNING

Do not immerse power cord, power plug or appliance in water or any other liquid. The water tank should never be removed or completely emptied during

PAC geRE header& CLEANING.....

CLEANING THE STEAM WAND AND FROTHING ATTACHMENT

Run steam to clear milk	Wipe steam wand after	Clean hole with pin	Remove tip	Soak tip overnight then
from wand after texturing	each use			re-attach

decalcifying.

DECALCIFYING THE MACHINE

•Remove the portafilter and frothing attachment. Pour the mixture of white vinegar and water into the water tank.

•Plug the machine into the power outlet and switch On.

•Press the POWER button to the On position.

•Place a large container under the group head and steam wand.

•When the brewing temperature has been reached all the button surrounds on the control panel will illuminate. Press and hold the 1 CUP or 2 CUP button to commence manual pour. Release the button once half the mixture of white vinegar and water has run through the group head.

•Set the STEAM/HOT WATER dial to the STEAM position and allow steam to run through the Steam Wand for approximately 2 minutes. Return the steam dial back to the STANDBY position.

•After decalcifying, remove the water tank and rinse thoroughly then refill with fresh cold water. To rinse the machine, repeat previous steps.

•The steam wand and frothing attachment should always be cleaned after texturing milk.

•Remove the frothing attachment and rinse in warm tap water.

•Wipe the steam wand with a damp cloth, and then with the steam wand directed back into the drip tray, briefly set the steam dial to the STEAM position. This will clear any remaining milk from inside the steam wand.

•Ensure the steam dial is in the STANDBY position. Press the POWER button to Off and allow the machine to cool.

•If the steam wand remains blocked, use the pin on the cleaning tool to clear the opening.

•If the steam wand continues to be blocked, the tip of the steam wand can be removed by using the spanner in the middle of the cleaning tool.

•Unscrew the tip with the cleaning tool.

•Soak the tip in hot water before using the pin on the cleaning tool to unblock. Replace the tip back onto the steam wand and secure with the cleaning tool.

24		25