Operating your Infuser™ Espresso Machine
OPERATING
your Infuser™ Espresso Machine
Before First Use
Machine Preparation
Remove and discard all labeling and packaging materials attached to your espresso machine. Ensure you have removed all parts and accessories before discarding the packaging.
Clean parts and accessories (water tank, portafilter, filter baskets and jug) using warm water and a gentle dish washing liquid and rinse well. Wipe the outer housing and drip tray with a soft damp cloth and dry thoroughly. Do not immerse the outer housing, power cord or power plug in water or any other liquid.
The water filter located inside the water tank will need to be removed before washing the water tank.
Conditioning the Water Filter
•Remove filter from the plastic bag and soak in a cup of water for 5 minutes.
•Rinse filter under cold running water.
•Wash the stainless steel mesh in the plastic filter compartment with cold water.
•Insert the filter into the filter holder.
•Set the dial date 2 months ahead.
•To install filter, push down to lock into place.
•Slide the water tank into position and lock into place.
NOTE
To purchase water filters contact Breville Customer Service Centre on 1300 139 798 (Australia) or
0800 273 845 (New Zealand)
FIRST USE
Initial Start Up
•Fill tank with water
•Press POWER on
•A pumping sound will be heard. The machine will reach operating temperature and go into Standby mode.
Flushing the Machine
It is recommended to complete a water flushing operation, without ground coffee, to ensure the machine has been conditioned.
When the machine has reached STANDBY mode, run the following 2 steps.
•Press the 2 CUP button to run hot water through the group head for 30 seconds.
•Activate hot water for 10 seconds.
•Repeat this cycle until the water tank is empty.
NOTE
Do not clean any of the parts or accessories in the dishwasher.
11