BR9013 BKC600XL_IB_AMEND.qxp 11/10/07 21:43 Page 10
Operating your Breville Gourmet Single Cup Brewer™ continued
9.Once the water is heated, the LCD screen will no longer indicate ‘HEATING’. The ‘BREW’ button will illuminate and flash for up to 60 seconds.
10.Press the 'BREW' button. This will start a cleansing brew which will complete the priming sequence. The LCD screen will no longer indicate 'PRIMING'. Hot water will flow into your mug. When the flow stops, discard the hot water.
11.The LCD screen will indicate ‘HEATING’ as the Brewer heats the water for the next brew cycle. Once the water is heated, the LCD screen may indicate ‘REFILL TANK’.
12.Fill the Water Tank with water until it is approximately 1 inch below the top edge.
13.The LCD screen will indicate ‘OPEN HEAD’. Open the Brewing Chamber Head by raising and lowering the Safety Locking Arm completely. The LCD screen will indicate ‘READY TO BREW’.
14.The
Brewing a K-Cup®
1.Follow the instructions, Installing the Water Filter (page 8) and the
2.The LCD screen will indicate ‘READY TO BREW’.
The and buttons will illuminate and the ‘BREW’ button will illuminate and flash for up to 60 seconds.
If the ‘BREW’ button is not pressed in 60 seconds, the LCD screen will indicate ‘OPEN HEAD’ and the ‘BREW’ button will be disabled to prevent accidental activation. To
Note
3.Place a cup or mug on the Drip Tray Plate. The drip tray plate and drip tray can be removed to accomodate taller mugs and travel mugs.
4.Raise the Safety Locking Arm. The Brewing Chamber will open toward you.
5.Select a K-Cup®.
6.Place in the lid or
There ar
7.Lower Brewin When indica button illumin
10