l the
BR9013 BKC600XL_IB_AMEND.qxp 11/10/07 21:43 Page 25
Troubleshooting
nts of the may need notice and lower ycle so
repeat
Note
different
doff. wer cord ank
o avoid
ment. runs the nd stored in let it hours
Possible problem
Brewer will not switch on
Brewer will not brew
Coffee is too weak or watery
Easy solution
•Plug the Brewer into an independent outlet.
•Check that the Brewer is plugged in securely.
•Plug into a different outlet.
•Reset circuit breaker if necessary.
•Make sure that the Power Switch has been turned on. The Water Tank
should be illuminated. The ‘BREW’ button, and buttons should be illuminated.
•After placing the
into the Brewing Chamber, ensure the Safety Locking Arm is pushed down
securely. The LCD screen should indicate ‘READY TO BREW’. The and
buttons should illuminate and the 'BREW' button should illuminate and flash for up to 60 seconds.
•If the LCD screen indicates ‘REFILL TANK’, add water to the Water Tank or make sure the Water Tank is attached correctly to the Brewer (page 15).
•If the LCD screen indicates ‘REFILL TANK’ even after refilling, contact Customer Service on
•If the ‘BREW’ button is not pressed in 60 seconds, the LCD screen will indicate ‘OPEN HEAD’ and the ‘BREW’ button will be disabled to prevent accidental activation. To
•The Exit Needle may be clogged (refer Cleaning the K-Cup® Holder, page 22).
•Reduce the brew size selection for a “stronger” tasting cup of coffee (refer to Setting the ‘BREW SIZE’ feature, page 20).
•Try an Extra Bold
torage, th fresh without ge 15).
There are over 150 varieties of Keurig
Note
25