Setting the Clock

The time of day appears on the display when the system is in the Standby mode or when the AUX function is selected.

While the time is showing on the display:

1.) Press the MEMORY/CLOCK-ADJ button on the front panel or the remote control once. The Hour digits begin to flash.

2.) Press the R-SKIP or F-SKIP buttons to adjust the display to the correct hour. Make sure to set 'AM' or 'PM' correctly.

3.) Press the MEMORY/CLOCK-ADJ button again. The Hour digits stop flashing and the Minute digits begin to flash.

4.) Press the R-SKIP or F-SKIP buttons to adjust the display to the correct minute.

5.) Press the MEMORY/CLOCK-ADJ button once more. The Minute digits stop flashing and the clock begins to run.

IMPORTANT: After pressing the MEMORY button you must press the R-SKIP

or F-SKIP buttons to adjust the display within 10 seconds while the digits are flashing. If the display stops flashing press the MEMORY button again and then

press the R-SKIP or F-SKIP buttons to adjust the display.

NOTE: If the system is disconnected from AC power for more than 2 days, it may be necessary to reset the clock when the power is restored.

1 0

ES11_ib022503.p65

25/2/2003, 16:05