KitchenAid KSRS25CNBL Factory Trim Kit, Complete the Installation, Remove the Door Panels

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

Style 3

1.Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.Thread the provided nut onto the water valve as shown.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A

B

A.Bulb

B.Nut (provided)

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

Complete the Installation

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Plug into a grounded 3 prong outlet.

2.Flush the water system. See “Prepare the Water System” or “Water and Ice Dispensers.”

NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container.

Factory Trim Kit

(on some models)

There may be an occasion when you will need to remove the factory-installed trim kit, such as moving the refrigerator to a new home or installing custom-made decorator panels. Please read all instructions before removing the trim kit and decorator panels.

Freezer Door Refrigerator Door

B A

C

B A A B

A. Decorator panels

B. Filler boards

C. Handles

Remove the Door Panels

NOTE: When removing and replacing decorator panels, only the handle is removed. All other trim pieces remain attached to the doors.

1.Remove the refrigerator and freezer handles:

■Using a Phillips screwdriver, remove the screws that hold each handle in place.

■Lift off handle. Make sure you keep screws for reattaching handles.

2.Remove the door panels:

■Open refrigerator or freezer door.

■Slide out decorator panel and filler board.

■Repeat process for other panels and filler boards.

■Store panel and filler boards to prevent scratching.

Replace the Door Panels

1.Replace the refrigerator or freezer door panels:

■Open refrigerator or freezer door.

■Slide the ¹⁄₈" (3.18 mm) decorator panel into place behind the side trim.

■Push the filler board into place behind the decorator panel.

■Repeat process for other panels and filler boards.

5