Check operation
17 n Turn power on.
-\
18 The range hood controls are located in a n grey panel on underside of the canopy. To
open the panel, press on the front edge of panel and release. The control panel will drop down.
I | | | 1 |
” | IQ I-w@ | 4-O | I |
, 4: | 0 1 Gs 01 | -mma1 | |
light switch | blower switch | blower speed switch |
19 n Check the operation of the range hood:
q Move light switch to “1” position. The light should turn on.
q Move blower switch to “1” position. The blower should operate.
q Move the blower speed switch to the far left; blower speed should be LOW. Move blower speed to right; blower speed should gradually increase until you reach HIGH speed at far right.
q Move blower and light switches to “0” position to turn blower and light off.
If range hood does not operate:
q Check that the circuit breaker is not tripped or the house fuse blown.
Grease Fire Hazard
To reduce the risk of a range top grease fire:
. Keep fan, filters and grease-laden surfaces clean.
l Always turn hood ON when cooking at high heat.
l Only use high heat setting on range when necessary.
l Use low to medium setting to heat oil.
l Never leave range unattended when cooking. l Always use cookware and utensils
appropriate to the type and amount of food being prepared.
In the event of a grease fire:
l Smother flames with a tight-fitting lid, cookie sheet or metal tray. Then turn off the element/burner.
l Evacuate and call the fire department if the flames do not go out immediately.
l Never pick up a flaming pan. You could be seriously burned.
l Do Not extinguish flames with water, wet dishcloths or towels. Water creates a violent steam explosion that could cause serious burns.
l ONLY use a fire extinguisher if:
1.It is a Class ABC extinguisher and you know how to use it.
2.The fire is small and contained in the area where it started.
3.You have called the fire department.
4.You can fight the fire with your back to an exit.
Failure to take these precautions could lead to serious personal injury or death.
Electrical Shock Hazard
. Use range hood only in the manner intended by the manufacturer. If you have questions about its use, contact the KitchenAid Consumer Assistance Center.
9 Disconnect power at service panel and lock service panel before servicing or cleaning unit.
9 If any electrical problem becomes evident during use, disconnect power to range hood at fuse or circuit breaker box.
Failure to follow these instructions could result in electrical shock or fire.
Operation
The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the range hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
Opening the range hood control panel:
The range hood controls are located in a grey panel on the underside of the canopy. To open the panel, press on the front edge of panel and release. The control panel will drop down.
” I-QI-w@ -i-Q I II
:6: 0 1 | @ | 01 | -mmmm |
light switch | blower | switch | blower speed switch |
Operating the light:
ON: Move the light switch to the “1” position.
OFF: Move the light switch to the “0” position.
Operating the blower:
ON: Move the blower switch to the “1rr position.
OFF: Move the blower switch to the “0” position.
Adjusting the blower speed:
The blower has variable speed control.
Move the switch to the far left for LOW speed and to the far right for HIGH speed.
Closing the range hood control panel:
Push up on the front edge of the control panel. The control panel will slide up into the canopy.
To get the most efficient use from your new range hood, read the
“Use and Care Information” section. Keep your KitchenAid Installation Instructions and Use and Care Guide close to range hood for easy reference.
Cleaning
Filters:
The filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean.
Exterior surfaces:
Clean the range hood with a mild detergent and soft cloth. Do Not use abrasive cleanser or steel wool pads.
Maintenance
clips
Replacing the light bulb:
Remove the retainer clips from both ends of the light cover. Carefully slide the cover all the way to the right. Then lower the left end of the glass below the support flange and remove the glass by sliding it back from the left.
Install a new fluorescent light bulb.
Position the right end of the light cover over the flange and slide the cover all the way to the right. Position the left end of the light cover over the flange and slide the cover back to left. Reinstall the retainer clips.
For assistance:
If you have questions about operating, cleaning or maintaining your range hood:
q Call the KitchenAid Consumer Assistance Center, l-(800) 422-l 230.
If you need service:
Maintain the quality built into your appliance by calling a KitchenAid-authorized service company. To obtain the name and number of an authorized service company:
q Contact the dealer from whom you purchased the appliance;
q Look in the Yellow Pages of your telephone directory under “Appliances - Household - Major - Service and Repair;”
q Call the KitchenAid Consumer Assistance Center, l-(800) 422-l 230.
