Disconnect power | KitchenAid KPEU722M instruction

10. Insert retractable downdraft vent into countertop cutout. Two people are recommended to support the weight of the downdraft vent during lifting. Position downdraft vent so it is centered in cutout and parallel to edge of cutout. Check that downdraft vent is vertical. Then attach lower support legs to cabinet floor with screws.

When attaching undercounter bracket to underside of countertop, make sure that the screw length will not go through countertop when tightened.

11. Attach one undercounter mounting bracket on front upper right corner of downdraft vent with slot over vent mounting hole and flange against countertop. Attach other bracket to left side of downdraft vent. Carefully drill starter holes through undercounter mounting brackets into underside of countertop. Insert appropriate length screws into holes and tighten brackets to countertop.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Connect ground wire to green ground screw in terminal box.

Failure to do so can result in death or electrical shock.

12. Disconnect power.

vent box knockout

wiring box cover

green	green
ground	ground
wire	screw

conduit connector

13. Feed the power supply cable through the conduit connector and into wiring box. Connect the white wires together with a twist-on wire connector. Connect the black wires together with a twist-on wire connector. Attach the green (or green and yellow) ground wire to eyelet with green ground screw and tighten screw. Replace wiring box cover.

green
ground	green
screw	green
	ground
	wire
	exterior-mounted
	vent motor wiring

14. Remove vent box knockout and install conduit connector.

Feed exterior-mounted vent motor wiring through conduit connector.

IMPORTANT: Do not wire the exterior vent motor black and white wires into the wiring box. Wires must be connected as shown. Connect the white wires together with a twist-on wire connector. Connect the black wires together with a twist-on connector.

Attach ground wire to eyelet with green ground screw and tighten screw.

Tighten conduit connector clamp screws.

15. Reconnect power.

microswitches behind filters

ON/OFF button

blower control knob

filter or filters
depending on	end cap
model	end cap

16. Push and hold for a few seconds the button on the top of the downdraft vent. Retractable section of downdraft vent will rise and blower will start. Position the top trim over the retractable section and snap trim into place.

17. Turn the control knob on side of vent to check the operation and speed of blower.

If blower does not operate:

•Check that filter or filters are pressed in as far as they will go.

•Check that circuit breaker is not tripped or house fuse blown.

•Reconnect power. Check that wire connections have been made correctly.

18. Connect vent to blower. Position vent to avoid wall studs and floor joists. Complete all vent work. Use duct tape to seal all joints. Vertical vent for wall- mounted installations should pitch down slightly toward the vent to allow moisture to run outside.

19. Install cooktop according to manufacturer’s instructions. Check that rear of cooktop overlaps edge of retractable downdraft vent by 3/8" (9.5 mm).

To get the most efficient

use from your new

retractable downdraft vent,

read the Use and Care Information section on page 12.

Keep Installation Instructions

and Use and Care

Information close by for

easy reference.

KPEU722M specifications

The KitchenAid KPEU722M is a versatile and innovative kitchen appliance designed to elevate your culinary experiences. Renowned for its durability and performance, this appliance embodies KitchenAid’s commitment to quality and user-friendly design.

One of the standout features of the KPEU722M is its powerful motor, which delivers excellent performance across various cooking tasks. Whether you are kneading dough, whipping cream, or mixing batters, this kitchen tool can handle it all with ease. The motor is designed for both efficiency and longevity, ensuring that it can withstand the demands of regular use in a busy kitchen.

Another key characteristic of the KPEU722M is its advanced planetary mixing action. This unique technology allows the mixing bowl to rotate while the beater moves in the opposite direction. As a result, all ingredients are thoroughly mixed and incorporated, delivering consistent results every time. This feature is particularly beneficial when making bread or chiffon cake, where uniform blending is essential.

In terms of design, the KPEU722M boasts an elegant and modern aesthetic that can complement any kitchen decor. It is available in various colors, allowing users to choose one that best fits their style. The appliance is also engineered for ease of use, with intuitive controls that provide a seamless user experience.

The KPEU722M comes with a range of attachments, including a flat beater, dough hook, and wire whip, further enhancing its versatility. Each attachment is designed to cater to specific tasks, enabling users to experiment with different recipes and techniques. Additionally, the bowl is spacious, allowing for large batches to be prepared at once, making it ideal for family gatherings or baking marathons.

Safety features are another hallmark of the KPEU722M. It incorporates a thermal overload protection system that protects the motor from overheating, ensuring the appliance operates safely during extended use. Furthermore, the non-slip base provides stability while mixing, preventing any accidents.

Overall, the KitchenAid KPEU722M is a powerful and stylish kitchen appliance that brings advanced mixing technology and convenience to the home cook. With its robust performance, thoughtful design, and essential features, it is a valuable addition to any kitchen, ideal for both novice chefs and seasoned professionals.