KitchenAid 30"(76, 2 CM) installation instructions AdjustLevelingLegs, InstallAnti-TipBracket

Page 10

AdjustLevelingLegs

1.If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs.

This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position.

NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard.

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

2.Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of ³⁄₁₆" (5 mm) is needed to engage the anti-tip bracket.

NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs.

3.When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final position, check that the anti- tip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation.

InstallAnti-TipBracket

Contact a qualified floor covering installer for the best procedure for drilling mounting holes through your type of floor covering.

Before moving range, slide range onto shipping base, cardboard or hardboard.

1.Remove template from the anti-tip bracket kit (found inside the oven cavity) or from the back of this manual.

2.Place template on the floor in cabinet opening so that the left edge is against cabinet and top edge is against rear wall, molding or cabinet.

3.Tape template into place.

4.If countertop is not flush with cabinet opening edge, align template with overhang.

If cabinet opening is wider than that specified in the “Location Requirements” section, adjust template so range will be centered in cabinet opening.

5.To mount anti-tip bracket to wood floor, drill two ¹⁄₈" (3.2 mm) holes at the positions marked on the bracket template. Remove template from floor.

To mount anti-tip bracket to concrete or ceramic floor, use a ³⁄₁₆" (4.8 mm) masonry drill bit to drill 2 holes at the positions marked on the bracket template. Remove template from floor.

6.Tap plastic anchors into holes with a hammer.

7.Align anti-tip bracket holes with holes in floor. Fasten anti-tip bracket with screws provided.

Depending on the thickness of your flooring, longer screws may be necessary to anchor the bracket to the subfloor. Longer screws are available from your local hardware store.

8.Move range close enough to opening to allow for final electrical connection. Remove shipping base, cardboard or hardboard from under range.

9.Move range into its final location making sure rear leveling leg slides into anti-tip bracket.

10.If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the “Location Requirements” section.

11.Continue installing your range using the following installation instructions.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents W10118262A Range Safety Table DES MatièresWhat to do if YOU Smell GAS ToolsandParts Installation RequirementsLocation Requirements Mobile home installations require Mobile Home Additional Installation RequirementsProduct Dimensions Freestanding Range Slide-in RangeFreestanding Ranges Installation ClearancesSlide-In Ranges Gas Supply Line ElectricalRequirementsGas SupplyRequirementsType of Gas Natural gasGas Pressure Regulator Gas Supply Pressure TestingCountertop Preparation Burner Input RequirementsMeasureforProperHeight Installation InstructionsUnpackRange Slide-In RangesAdjustLevelingLegs InstallAnti-TipBracketMakeGasConnection RemoveWarmingorStorageDrawerVerifyAnti-TipBracketLocation LevelRangeFreestanding Models Typical flexible connectionComplete Connection Slide-In ModelsElectronic Ignition System If flame needs to be adjusted Adjust Oven Bake Burner Flame if neededAdjust Oven Broil Burner Flame if needed Check Operation of Oven Bake BurnerTo Replace Warming Drawer CompleteInstallationReplace Oven Racks and Warming or Storage Drawer To Replace Storage DrawerTo Convert Gas Pressure Regulator GAS ConversionsLP GasConversion Gas pressure regulatorTo Convert Standard Surface Burners To Convert TripleTier Flame Burners on some modelsTo Convert Oven Bake Burner NaturalGasConversionTo Convert Oven Broil Burner To Convert TripleTier Flame Burner on some models Plate External gas orfice spud Internal gas orifice spud Sécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteExigencesdemplacement Exigences D’INSTALLATIONOutillageetpièces Dimensions du produit Cuisinière autoportante Cuisinière encastréeCuisinières autoportantes Dégagements de séparation à respecterCuisinières encastrées Type de gaz SpécificationsélectriquesSpécificationsdel’alimentation engaz Gaz naturelDétendeur de gaz PréparationduplandetravailCanalisation de gaz Débit thermique des brûleursMesurespourunehauteurappropriée Instructions DinstallationDéballage de la cuisinière Cuisinières encastréesInstallationde labrideantibasculement RéglagedespiedsdenivellementRéglage de l’aplomb de la cuisinière Vérificationdelemplacementdela bride AntibasculementRetrait dutiroir-réchaudoudutiroir De remisage Retrait du tiroir-réchaudRaccordement typique par raccord flexible RaccordementàlacanalisationdegazRaccordement typique à une canalisation rigide Compléter le raccordementAllumage initial et réglages des flammes SystèmedallumageélectroniqueCuisinière encastrée Brûleur TripleTierContrôle du fonctionnement du brûleur du four Si le brûleur ne sallume pas correctementRéglage de la taille des flammes Réglage du brûleur TripleTierContrôle du fonctionnement du brûleur du gril Réinstallation du tiroir-réchaudRéinstallation du tiroir de remisage Sil est nécessaire de régler la taille des flammesConversionpourlalimentationaupropane Acheverl’installationConversions Pour Changement DE GAZ Conversion du détendeurConversion des brûleurs standard de la table de cuisson DétendeurConversion du brûleur du four Conversion du brûleur du grilConversionpour lalimentationau gaznaturel Chiffre gravé Holes in bracket Trous dans la bride Imprimé aux É.-U

2 CM), 30"(76 specifications

The KitchenAid 30" (76.2 cm) range is a stunning addition to any culinary space, merging professional-grade performance with sleek design. Designed for those who are passionate about cooking, this range offers a comprehensive suite of features that enhance both functionality and style.

One of the standout features of the KitchenAid 30" range is its powerful cooking capabilities. It comes equipped with a variety of burners that provide ample options for simmering, boiling, or searing. The range's high-performance burners deliver precise heating, thanks to the dual-fuel technology that combines the benefits of gas and electric cooking. This allows for quick temperature adjustments and consistent cooking results that every home chef strives for.

The oven capacity of the KitchenAid 30" range is impressive, with generous space that accommodates multiple dishes simultaneously. Its convection oven provides even cooking by circulating hot air, ensuring that pastries rise perfectly and roasts cook evenly. With several cooking modes, including bake, broil, and self-clean, this oven guarantees versatility for any recipe.

Additionally, the KitchenAid range features an innovative steam rack, which enriches dishes with moisture and prevents drying during the cooking process. This technology is particularly beneficial for baking, imparting a professional touch to homemade breads and pastries.

The exterior design of the KitchenAid 30" range is both elegant and durable. Constructed from high-quality stainless steel, it resists scratches and smudges, ensuring a polished look in any kitchen. Seamless edges and professional knobs provide a contemporary aesthetic, making it not just an appliance but a centerpiece in the kitchen.

For safety and convenience, the range includes a cooktop lock feature that prevents accidental ignition, along with a temperature gauge that provides real-time readings. This ensures a worry-free cooking experience.

The KitchenAid 30" (76.2 cm) range is a perfect blend of style and performance, making it an ideal choice for anyone looking to elevate their culinary experience. With its robust features, innovative technologies, and sophisticated design, it stands as a testament to KitchenAid's commitment to quality and excellence in kitchen appliances.
Top Page Image Contents