KitchenAid Electric Built-In Microwave/Oven Combination installation instructions Install Oven

WARNING

Excessive Weight Hazard

Use two or more people to move and install oven. Failure to do so can result in back or other injury.

1.Using 2 or more people, lift oven partially into cabinet cutout using the oven opening as an area to grip.

NOTE: Push against seal area of oven front frame when pushing oven into cabinet. Do not push against outside edges.

2.Push against seal area of front frame to push oven into cabinet.

4.Securely fasten oven to cabinet using the #8-14 x 1" screws (2 for single oven, 4 for double oven) provided. Insert the screws through holes in mounting rails. Do not overtighten screws.

A

B

A. Mounting rail

B. Insert #8-14 x 1" screw.

5.On some models, the oven vent is taped to the side of the oven.

With one #8-14 x ³⁄₈" screw for each side of the vent, fasten vent securely to the oven.

3.Push oven completely into cabinet and center oven into cabinet cutout.

A

B

A. #8-14 x ³⁄₈" screw

B. Oven vent

6.Replace oven racks.

7.Replace oven door(s) by inserting ends of hinges into hinge slots in the oven frame.

8.Push hinges in as far as they will go and open the oven door. You should feel the oven door drop into place.

9.Rotate both hinge latches back to the locked position.

10.Check that the door is free to open and close. If it is not, repeat the removal and installation procedures. See “Remove Oven Door” section.

11.Reconnect power.

12.Display panel will light briefly, and “PF” should appear in the display.

13.If display panel does not light, please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your oven.