USING THE PROCESSING BLADE/DISCS
All blades must be handled carefully as they are sharp!
Push down
Using the processing/mixing blade
a. Select either the processing or plastic mixing blade
b. Place the processing /mixing blade over the drive shaft and push down.
Using the slicing/grating discs.
a. Select the desired slicing/grating disc and assemble into the disc holder.To fit the stainless steel disc onto disc holder, fit left side of disc (when writing is towards you), with locating tab into holder, then push right side down firmly until it locks into place. Fit the end without the push up marking in first.Then push the “push up” side down firmly until it locks into place.
Locate tab
b.To remove disc, hold disk away and place thumbs underneath disc at top of disc marked “push up” and push out.The disc may be tight for the first few times.
Correct placement of the processor lid
Place the lid on top of the bowl, align the indicator line on the lid with the circle 
on the bowl.
7