KitchenAid KUIS185S manual For the Plumber, Connect to Water, Condensate Pump, Connect the Drain

FOR THE PLUMBER

CONNECT TO WATER

(observe local codes)

1 Use l/o” OD soft copper tubing for the cold water

SUPPlY.

2P rove‘d e a convenient manual shut-off valve tn the

water lrne

3 Position the tubing so It can enter the access hole

located in the right-hand rear of the cabrnet. The tubing should extend beyond the cabinet front when the cabinet is pushed back into position. See Figure 5.

NOTE:

Always purge the water line before making the final connection to the inlet of the water valve to prevent possible water valve malfunction.

After the cabinet is in place, bend the tubing to meet the connection at the water valve. The garden hose threaded compression fitting is found in the parts bag. This joint provides a convenient disconnect for service. Be sure the tubing is clear of compressor, to prevent rattle.

CONDENSATE PUMP

1.When drain connection below the level of the unit is not available a condensate pump may be used to lift the water to an available drain.

2.Install condensate pump on floor behind ice maker with discharge tube to the rear. Run bin drain directly into pump as shown in Figure 5A.

3.Run power cord thru hole into unit compartment (See Figure 5A)

4.Remove lower grille assembly. (See Figure 5B)

5.Remove shunt from receptable and plug in condensate pump. (See Figure 5C)

NOTE:

Do not discard shunt that is removed from receptable. This must be replaced if unit is to be operated without condensate pump.

CONDENSATEPUMPHASPRESSURE	ADD	PLASTIC		HOSE
SWITCH THAT CYCLES	FROM BIN		DRAIN
ITS PUMP.	DIRECTLY		TO	PUMP
/ a	%”	ID TUBE

CONNECT THE DRAIN

(observe local codes)

1 Th e unrt IS provrded with a gravity drain

2 The ideal installation has a standpipe (1’14” mrnimum) installed directly below the outlet of the drawn tube. Refer lo Figure 5 for the proper location of the standpipe.

3 It may be desirable to insulate drain line thoroughly up to drain Inlet.

RIGHT END VIEW BACK VIEW

FIGURE 5

			I	VALVE
1/4”O.D.	WATER			/		4	4” LONG	5/0”	I.D.	RUBBEF
LINE COMPRESSION							DRAIN	TUBE	- RUN TO
FITTING	AT	WATER			------I<	I	, OPEN DRAIN
VALVE
							l-1/4”	MINIMUM
							HOLE		FOR	FIELD
						3”	SUPPIED		WATER
BEND		FIELD	SUPPLIED		WATER
						LINE	/
TO	CONNECT		TO	WATER	VALVE	FITTING

RCORD THIS HOLE

SUPPLIED

RLINE THIS HOLE