KitchenAid KUDS40FVPA, KUDE70FVPA, KUDE60FVPA, W10056407A, KUDS50FVPA Determine Cabinet Opening

Wiring configuration

Power supply wire:	Terminal box wire:
white	white
black	black
ground wire	ground connector

If needed, see website for animated representation of this step. Visit www.kitchenaid.com under FAQ tab.

4 Power Cord - Secure cord on strain relief

Tighten strain relief screws to secure cord.

5 Power Cord—Reinstall

terminal box cover

Place wires inside terminal box. Insert tabs on left side of cover. Make sure wires are tucked inside box. Close cover ensuring wires are not pinched. Use 1/4” nut driver and previously removed screw to secure cover.

NOTE: Do not plug into outlet until instructed to do so.

Determine Cabinet Opening

1 Measure cabinet opening

Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you will need to measure the lowest point on the underside of the countertop and the highest point on the floor). Refer to “Dishwasher Height Adjustment Chart” for wheel position and the number of turns needed.

Dishwasher Height Adjustment Chart

Cabinet	Wheel	Number of turns
opening height	position	on front leg
33 7/8” (86.0 cm)	remove	All the way up
34” (86.4 cm)	1	10
34 1/4” (87 cm)	2	5
34 1/2” (87.6 cm)	3	0

NOTE: If the minimum cabinet opening height is less than 34”(86.4 cm), the rear wheels can be removed for additional clearance. This will allow the dishwasher to fit into a 33 7/8” (86 cm) high cabinet opening, but the dishwasher will be more difficult to move. (Measurements are approximate. Wheels and legs are preset at the factory for 34 1/2” [87.6 cm].)

2 Adjust wheels and legs

1

2

3

wheel

Turn both leveler legs to the same height. Put wheels in the required position determined from “Dishwasher Height Adjustment Chart.”

13