OPTION SELECTIONS
OPTIONS | DISH LOAD TYPES | DESCRIPTIONS | USE WITH: |
For best drying results, dry dishes with heat.
This option with the use of rinse aid will provide the best drying performance.
All cycles, except Quick Cleanup and Rinse Only. Automatic with all wash cycles unless you turn it off.
To sanitize your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers.
Raises the water temperature in the final rinse to approximately 155°F (68°C). This high temperature rinse sanitizes your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the cycle.
Sensor Wash, Heavy Duty and Normal Wash. Only these sanitization cycles have been designed to meet the
NSF/ANSI
requirements.
|
| Loads containing tough, | Increases the target water temperature during the wash | Sensor Wash, Heavy |
|
| portions of the cycle. | Duty or Normal Wash | |
|
|
| Adds heat, wash time and water to the cycle. |
|
|
|
|
|
|
|
|
|
|
|
To run your dishwasher at a later time or during off- peak hours.
Delays the start of a cycle up to 4 hours. | All cycles, except Rinse |
Select a wash cycle and options. Press 4 Hour Delay. Press | Only |
| |
START/RESUME. Close the drawer firmly. |
|
Control Lock To avoid unintended use of your dishwasher, or cycle and option changes during
a cycle.
To turn on Lock, press and hold ProDry for at least | Anytime |
3 seconds. |
|
To turn off Lock, press and hold ProDry for at least |
|
3 seconds. |
|
When Control Lock is lit, all buttons are disabled. If you press |
|
any pad while your dishwasher is locked, the light flashes |
|
3 times. The dishwasher drawer can be opened while the |
|
controls are locked. |
|
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE | COMMENTS |
To start or resume a wash cycle
If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/Resume indicator flashes. To restart the drawer, open the drawer, press Start/Resume and close the drawer firmly within 4 seconds./
To cancel wash | Close the drawer firmly. The dishwasher starts a |
cycle | drain completely. If the Cancel button is pressed a second time, the drawer will turn off. |
To follow the progress and status of your dishwasher cycle
Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required temperature. The light goes off when you open and close the drawer or press CANCEL.
The rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.
6