KitchenAid W10078153B guide

11.Align the top edge of the customer-supplied custom panel with the top of the console.

12.Drill two 3/32" pilot holes 1/2" (13 mm) deep, into the customer-supplied custom panel, through the holes in the top corners on the inner panel, as shown.

1.With a TORX® screwdriver, remove three screws from both sides of door; hold the outer panel up while removing the screws.

13. Install the two #8-18 x 1-3/8" screws from the literature package in the top corners of the inner panel.

inner panel

align top edges

drill through these holes

1-3/8"screw

3 screws

outer panel

2.	Gently set outer panel aside.
3.	Lay the cutomer-supplied custom panel face down on a
	protective, non-scratching surface.
4.	Position the outer panel on the back of the customer-
	supplied custom panel as shown; make sure top edge of

14.Tighten the six side screws reinstalled in Step 10.

Option 2: For models KUDC03IT, KUDK03IT and KUDL03IT

All models require an accessory option to attach custom panels. Kit No. 8171555 (black), 8171556 (white) or 8171557 (biscuit) are available. To order, call customer service at 800-444-1230.

NOTE: A custom full front panel must weigh no more than 14 pounds (6.3 kg) and must be made to specific dimensions. It is recommended that a cabinetmaker cut the custom panel because of the precise dimensions needed.

IMPORTANT: Use a moisture resistant sealer on both sides and all edges of the panel to protect it from humidity.

NOTE: These dimensions are for frameless custom panel models with a 4-inch (10.2 cm) console only.

			*25-29/32" (65.8 cm)
	23-3/8" (59.3 cm)		*25-29/32" (65.8 cm)
	23-3/8" (59.3 cm)

3/4"

(19.1 mm)

1/8" (3.2 cm)

custom panel dimensions

1/8" (3.2 cm)

*This dimension is for 4" (10.2 cm) toe kick. If the installation needs a higher toe kick, adjust the height of the wood panel accordingly. Not recommended for toe kicks greater than 6" (15.2 cm).

the outer panel is aligned with the top edge of the

customer-supplied custom panel, and both panels are

centered side to side.

mark 4

inner holes

outer panel	align top
	edges

customer-supplied

custom panel

5.Mark all four hole locations; remove outer panel and drill 3/32" pilot holes 1/2" (13 mm) deep, in customer-supplied custom panel.

6.Place the outer panel on the back of the customer- supplied custom panel and align holes.

7.Attach outer panel to back of customer-supplied custom panel with four #10 x 1/2" wood screws (not supplied). If the customer-supplied custom panel is less than 3/4" (1.9 cm) thick where the screws are attached, shorter screws maybe required.

8.Attach the panel assembly to the door by reinstalling the three screws on each side.

3 screws