|
| XDVDN8190 OPERATION | ||
|
|
|
|
|
|
|
| Troubleshooting | |
|
|
| ||
| Bluetooth | |||
Problem | Cause |
| Action | |
Please connect | There is no mobile device connected to the |
| Pair and or connect a mobile device to the head unit as | |
first appears in the | head unit |
| described on page 75 | |
display |
|
|
|
|
Mobile device will | Bluetooth function is not active on the head unit |
| Activate Bluetooth function as described on page 19 | |
not connect to the | Bluetooth function is not active on the mobile |
| Refer to the owner's manual of your mobile device | |
head unit |
| |||
device |
|
|
| |
|
|
|
| |
| A mobile device is already connected to the head |
| Disconnect current mobile device first, then connect desired | |
| unit This head unit can only be connected to one |
| mobile device | |
| device at a time |
|
|
|
ERROR! Connect | The time limit for the pairing mobile device has |
| Pair the mobile device within 120 seconds | |
Timeout appears in | been reached |
|
|
|
the display |
|
|
|
|
Pairing Fail appears | The attempted pairing process has failed |
| Retry the pairing process again | |
in the display |
|
|
|
|
Mobile device | The Connect function is set to Manual. When |
| Set Connect function to Auto as described on page 74 | |
will not connect | the Connect function is set to Manual, the |
|
|
|
to the head unit | head unit will not connect to any mobile device |
|
|
|
automatically | automatically |
|
|
|
Ring tone can not | Ring tone volume is turned down |
| Increase the volume of the ring tone using the rotary encoder | |
be heard through |
|
| during the ringing process | |
the speakers | MUTE function is activated on the head unit |
| Press MUTE to cancel the mute function and resume audio | |
|
| |||
|
|
|
| |
Echo or noise is | Possible road noise or interior interference |
| Close all open windows and turn off any fans or A/C | |
heard during a | Microphone opening on the front panel is |
| Clear any obstacles in front of microphone opening | |
phone call |
| |||
obstructed |
|
|
| |
|
|
|
| |
Call is connected | Audio is routed to the mobile device |
| Press Audio Transfer to allow audio from the phone to be | |
(but no audio can |
|
| heard through the speakers | |
be heard through | Bluetooth audio is heard through the front |
| Adjust fader forward so there is audio to the front speakers. If | |
the speakers) |
| |||
channel speaker outputs or the front preamp |
| amplifiers are used only, be sure to use front preamp outputs | ||
|
| |||
| outputs only |
|
|
|
| Bluetooth mode includes memory volume. |
| Adjust Bluetooth volume level above 0 | |
| If Bluetooth volume is set to 0 when a call comes |
|
|
|
| in, no audio will be heard |
|
|
|
Call is answered | Auto Answer function is set to On |
| Set Auto Answer function to Off as described on page 74 | |
automatically |
|
|
|
|
Caller ID does not | The calling mobile device is not set to send the |
| Some devices may not communicate or work properly with | |
appear during | Caller ID or, the service is not available |
| this head unit | |
incoming call |
|
|
|
|
XDVDN8190 does | Cell phone ringer is set to off |
| Set cell phone ringer to “on” | |
not ring when |
|
|
|
|
receiving a call |
|
|
|
|
88