Care and Cleaning

English

The Blender pitcher, locking collar and blade assembly can be easily cleaned as individual components or together without disassembly.

•Clean the Blender thoroughly after every use

•Do not immerse the Blender base or cord in water

•Do not use abrasive cleansers or scouring pads

To Clean Individual Components

1.Lift the pitcher assembly in a straight, upwards motion off the Blender base. Place jar assembly on a hard surface.

Then, while holding locking collar, rotate pitcher counterclockwise, two clicks, to separate locking collar and blade assembly, and sealing ring from the pitcher. Wash components with

soapy water. Rinse and wipe dry. NOTE: Pitcher can be placed in the bottom rack of an automatic dishwasher. For best results, hand washing is recommended for the lid, ingredient cup, locking collar and blade assembly, and sealing ring.

Pitcher

Sealing

Ring

Locking

Collar

and Blade

Assembly

To Clean Without Disassembly

1.Put the pitcher on the Blender base, fill half full with warm (not hot) water, and add 1 or 2 drops of dishwashing liquid. Put the lid on the pitcher, press the STIR speed setting, and run the Blender for 5 to 10 seconds. Remove the pitcher and empty contents. Rinse with warm water until clean.

2.To clean the lid and ingredient cup, wash in warm soapy water, then rinse and dry thoroughly.

3.Wipe the Blender base and cord with a warm, sudsy cloth; wipe clean with a damp cloth, and dry with a soft cloth.

2.Wipe the Blender base and cord with a warm, sudsy cloth; wipe clean with a damp cloth, and dry with a soft cloth.