Troubleshooting
The Blender does not operate when a setting is selected:
No indicator lights are lit.
Check to see if the Blender is plugged into an outlet. If it is, press “O”, then unplug the Blender. Plug it back in to the same outlet. If the Blender still does not work, check the fuse or circuit breaker on the electrical circuit the Blender is connected to and make sure the circuit is closed.
English
The Blender stops while blending:
| The Blender may be overloaded. If the | |
| Blender becomes overloaded when | |
| blending heavy ingredients, it will | |
| automatically shut off to prevent damage | |
| to the motor. Press “O” to reset the Blender | |
| and unplug the power cord. Remove the | |
| pitcher assembly from the base and divide | |
All indicator lights are flashing | contents into smaller batches. Adding | |
liquid to the pitcher may also reduce the | ||
at the same time. | ||
load on the Blender. | ||
| ||
| The Blender may be jammed. If it’s | |
| jammed, the Blender will stop running | |
| to prevent damage to the motor. Press | |
| “O” to reset the Blender and unplug | |
| the power cord. Remove the pitcher | |
| assembly from the base and with a | |
| scraper, free the blades by | |
Indicator lights are flashing alternately. | removing the contents at the bottom of | |
the pitcher. | ||
|
The Blender turns on, but blades will not rotate.
| The pitcher is not properly secured in |
| the locking collar, not allowing couplers |
| to engage. Remove pitcher from base |
Gap | and fully seat into collar. Press down and |
rotate pitcher clockwise in the locking | |
| collar past the second “click.” This will |
| allow the pitcher assembly to engage the |
| coupler. See page 5 for Blender Assembly. |
If the problem cannot be fixed with the steps provided in this section, then contact an authorized service center (see page 14).
Do not return the Blender to the retailer – they do not provide service.
11