Hotpoint 19 Care and cleaning of the refrigerator, Cleaning the Outside, Cleaning the Inside

Page 11

Care and cleaning of the refrigerator.

www.Hotpoint.com

Safety

Cleaning the Outside

The door handles and trim. Clean with a cloth dampened with soapy water. Dry with a soft cloth.

Keep the outside clean. Wipe with a clean cloth lightly dampened with kitchen appliance wax or mild liquid dish detergent. Dry and polish with a clean, soft cloth.

Do not wipe the refrigerator with a soiled dish cloth or wet towel. These may leave a residue that

can erode the paint. Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and weaken the paint finish.

Instructions

Cleaning the Inside

To help prevent odors, leave an open box of baking soda in the fresh food and freezer compartments.

Unplug the refrigerator before cleaning. If this is not practical, wring excess moisture out of sponge or cloth when cleaning around switches, lights or controls.

Use warm water and baking soda solution— about a tablespoon (15 ml) of baking soda to a quart (1 liter) of water. This both cleans and neutralizes odors. Thoroughly rinse and wipe dry.

Avoid cleaning cold glass shelves (on some models) with hot water because the extreme temperature difference may cause them to break. Handle glass shelves carefully. Bumping tempered glass can cause it to shatter.

Do not wash any plastic refrigerator parts in the dishwasher.

Do not clean with any products containing detergent, bleach or ammonia. They may damage the refrigerator.

Operating Instructions Installation

Condenser

There is no need for routine condenser cleanings in normal home operating environments. However, in environments that may be particularly dusty or greasy, the condenser should be cleaned periodically for efficient refrigerator operation.

For models with a base grille, the grille must be removed in order to clean the condenser.

To remove the base grille:

Grasp it about 6″ from each end and pull its bottom edge toward you.

To replace the base grille:

Insert the tops of the metal clips into the oval vents, making sure one of the plastic tabs on the back of the grille goes into each

of the oval vents. Then push the bottom of the grille forward until it snaps into place.

Cleaning the condenser:

Sweep away or vacuum up dust.

For models with a base grille, reach the condenser by inserting a brush or vacuum hose into the oval holes.

For models without a base grille, reach the condenser by inserting a brush or vacuum hose under the bottom of the refrigerator.

For best results, use a brush specially designed for this purpose. It is available at most appliance parts stores.

Instructions Troubleshooting Tips

Behind the Refrigerator

Be careful when moving the refrigerator away from the wall. All types of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces.

BEFORE moving the refrigerator away from the wall, be sure to adjust the leveling legs up. (See Rollers and Leveling Legs.)

Pull the refrigerator straight out and return it to position by pushing it straight in.

Moving the refrigerator in a side direction may result in damage to the floor covering or refrigerator.

When pushing the refrigerator back, make sure you don’t roll over the power cord or icemaker supply line

(on some models).

11

Consumer Support

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Write the model and serial numbers here Model # Serial # RefrigeratorsSafety Precautions Refrigerants Before You Throw Away Your Old Refrigerator or FreezerHOW to Connect Electricity About the controls on the refrigerator Control SettingsTo replace About the shelves and binsRearranging the Shelves To removeSlide-Out Spillproof Shelf on some models Safety InstructionsAdjustable Bins on the Door on some models Spillproof Shelves on some modelsFruit and Vegetable Crispers Adjustable Humidity Crisper on some modelsAbout the crispers and pans ShelfSaver Rack About the additional featuresAbout crisper removal Crisper RemovalConsumer Support About the automatic icemakerInstructions Condenser Care and cleaning of the refrigeratorCleaning the Outside Cleaning the InsideRefrigerator Compartment-Upper Light Consumer Support TroubleshootingPreparing for Vacation Rollers and Leveling Legs Water Supply to the IcemakerRefrigerator Location ClearancesWhat YOU will Need Before YOU BeginDrill the Hole for the Valve Shut OFF the Main Water SupplyChoose the Valve Location Connect the Tubing to the Valve Fasten the Shutoff ValveTighten the Pipe Clamp Route the TubingStart the Icemaker Connect the Tubing to the RefrigeratorTurn the Water on AT the Shutoff Valve Plug in the RefrigeratorRemove the Freezer Door Important NotesTools YOU will Need Transfer TOP Hinge to the Left Remove the Refrigerator DoorTransfer Door Stops Transfer Bottom Hinge Bracket to the LeftTransfer Center Hinge Bracket to the Left Transfer Refrigerator Door Handle to the Right Rehang the Freezer Door Transfer Freezer Door Handle to the RightRehang the Refrigerator Door Hummm Whoosh Normal operating soundsBefore you call for service… On some models See Installing the water lineSee Care and cleaning Automatic icemakerOrange glow Hot air from bottomRefrigerator Food freezingGeneral Electric Company Consumer Product Ownership Registration Troubleshooting Tips Consumer Support Operating Instructions Safety Instructions GE Will Replace Installation InstructionsWhat Is Not Covered Real Life Design Studio Schedule ServiceParts and Accessories Consumer Support Hotpoint Website

19 specifications

Hotpoint 19 is a versatile and innovative kitchen appliance that seamlessly blends functionality with modern design. This refrigerator offers an ideal solution for contemporary kitchens, combining ample storage space with cutting-edge technology to enhance users' cooking and food preservation experiences.

One of the standout features of the Hotpoint 19 is its spacious interior. With a capacity that can accommodate a large family’s needs, it includes adjustable shelves and door bins, allowing users to organize their groceries efficiently. The flexible shelving makes it easy to store large items, such as pitchers or party trays, ensuring that meal prep is always convenient.

In terms of technology, the Hotpoint 19 is equipped with energy-efficient cooling systems. It employs advanced cooling technology that maintains a consistent temperature throughout the refrigerator, preventing temperature fluctuations that can harm food quality. The refrigerator also features a frost-free design, eliminating the need for manual defrosting and making maintenance easy.

The Hotpoint 19 also boasts a Multi-Air Flow system, which circulates cool air throughout the fridge to maintain a uniform temperature. This feature not only preserves freshness but also minimizes odors, keeping food tasting as it should. The inclusion of LED lighting enhances visibility inside the fridge, allowing users to quickly locate their food items.

Another notable characteristic of the Hotpoint 19 is its user-friendly control panel. The intuitive interface allows users to adjust temperature settings and monitor the appliance with ease. There are also dedicated sections for specific types of food, such as fruits, vegetables, and dairy, optimizing storage conditions for each category.

The exterior design of the Hotpoint 19 is sleek and modern, available in various finishes to match any kitchen décor. The subtle curves and stylish handles provide both aesthetic appeal and ergonomic functionality. Additionally, the appliance comes with a range of customizable options, from different color finishes to handle styles, allowing consumers to find the perfect fit for their homes.

In summary, the Hotpoint 19 combines style and practicality, making it a top choice for anyone in need of a reliable and efficient refrigerator. With its innovative features, energy-saving technologies, and sleek design, the Hotpoint 19 is an excellent addition to modern kitchens, ensuring food preservation and user convenience.
Top Page Image Contents