Hotpoint dimensions RB536BCAD-Hotpoint 5.0 Cu. Ft. Free-Standing Electric Range, 29-7/8, 240V

RB536BCAD—Hotpoint 5.0 Cu. Ft. Free-Standing Electric Range

Dimensions (in inches)

29-7/8 7-1/2

KW Rating

7-1/2

REAR

WALL

2-1/4

46-1/2

1/4†

26-3/8*

46-3/8

*Dimensions from wall to front of closed oven door. Dimensions from wall to front of closed oven door handle is 28-1/2”.

7

3-1/2

CENTER LINE

	240V	12.6
5	208V	9.9

2-1/4

Receptacle Locations: For 30" Free-Standing Ranges locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation. See shaded area in drawing for location of electrical outlet box. Recommended outlet locations allow range to be installed directly against rear wall.

Note: 30" Ranges conform to U.L. requirements for 0" spacing from adjacent walls above countertops. However, some kitchen cabinet finishes can be damaged by heat from the range heating elements. It is recommended that a clearance of at least 1-1/2" be maintained to walls. Where varnished wood or plastic film finishes are used, a minimum clearance of 6" should be maintained.

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

†The range may be placed with a 0” clearance (flush) at the back walls if the range side trims extend beyond the cabinet fronts at least 1/4”.

Self-Clean models only.

All GE ranges are equipped with
an Anti-Tip device. The installation		Listed by
of this device is an important,
		Underwriters
required step in the installation
	R	Laboratories
of the range.

Specification Revised 6/00