Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out any work on it.

Cleaning the appliance

•Slight differences in colour on the front of the oven are due to the different materials used, i.e. glass, plastic or metal.

•Any shady areas resembling grooves on the oven door glass are caused by reflections from the oven light.

•The enamel is branded at very high temperatures. This process may cause colour variations. This is normal and will not affect appliance operation in any way. The thin edges of the sheet metal cannot be entirely enamelled and may therefore appear to be unfinished. This will not affect the rust protection.

•The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances.

•The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.

•All accessories - with the exception of the sliding racks - can be washed like everyday crockery, and are even dishwasher safe.

•We recommend that detergents are not sprayed directly onto the control panel, but that a sponge

is used instead.

!Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

!The door of LED INSIDE models cannot be removed.

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram). To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

		1. Remove the
	Lamp Holder	glass cover of the
	compartment	lamp-holder.
		2. Remove the
	Lamp	light bulb and
	Lamp	replace it with a
		replace it with a
		similar one:
	Glass cover	halogen lamp
	Glass cover	voltage 230 V,
		voltage 230 V,
		wattage 25 W,
		cap G 9.
	3. Replace the glass cover (see diagram).

!Do not touch the light bulb directly with your hands.

Sliding rack kit assembly

dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack.

For more thorough cleaning purposes, the oven door may be removed:

1.Open the oven door fully (see diagram).

2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers A (see figure).

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24