Denon ADV-M51 manual Parameters, Subwoofer SW FREQ. frequency, Assignment of low frequencies

Page 35

NOTE:

Select the speaker size not by the physical size of the speaker but by the speaker’s capacity to reproduce low frequencies of 100 Hz or less. If you do not know, determine the best setting by comparing the sound when the setting is set to “Small” and “Large”, keeping the volume low enough to prevent damage to the speaker.

NOTE:

Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency (approximately 100 Hz and below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.

Parameters

Large…… Select this when using speakers that can fully reproduce

low sounds of below 100 Hz.

Small…… Select this when using speakers that do not provide

sufficient volume for playing low frequencies of 100 Hz and less. When this setting is made, frequencies below the frequency set at the subwoofer frequency setting are assigned to the subwoofer.

Yes/No…. Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.

If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, speakers.

For the majority of speaker system configurations, using the SMALL setting for main speakers and Subwoofer On with a connected subwoofer will yield the best results.

ENGLISH

Subwoofer (SW FREQ.) frequency

For the subwoofer frequency at the speaker setting screen, set the bass crossover frequency for playback from the subwoofer.

Select “80 Hz”, “120 Hz”, “150 Hz” or “180 Hz” (-6 dB for each). Bass sound below these frequencies is played from the subwoofer.

(This is set to “150 Hz” by factory default.)

Assignment of low frequencies

In the Dolby Digital, Dolby Pro Logic II, DTS, and virtual surround modes, the low frequency signals for channels whose speaker settings are set to “Small” are assigned to the subwoofer. The low frequencies of channels set to “Large” are played from those channels.

(If set to “120 Hz”, channels set to “Small” play sounds of 120 Hz and greater, while bass frequencies of under 120 Hz are played from the subwoofer.)

In surround modes other than the ones listed above, low frequencies below the frequency set at the subwoofer frequency setting are played from the subwoofer regardless of whether the speakers are set to “Large” or “Small”.

Set the subwoofer frequency according to the low frequency playback abilities of your speakers and subwoofer.

Subwoofer mode

The subwoofer mode setting is only valid when “LARGE” is set for the front speakers and “YES” is set for the subwoofer in the “SPEAKER CONFIGURATION” settings.

When the “LFE+MAIN” playback mode is selected, the low frequency signal range of channels set to “LARGE” are produced simultaneously from those channels and the subwoofer channel. In this playback mode, the low frequency range expand more uniformly through the room, but depending on the size and shape of the room, interference may result in a decrease of the actual volume of the low frequency range.

Selection of the “LFE” play mode will play the low frequency signal range of the channel selected with “LARGE” from that channel only. Therefore, the low frequency signal range that are played from the subwoofer channel are only the low frequency signal range of LFE (only during Dolby Digital or DTS signal playback) and the channel specified as “SMALL” in the setup menu.

Select the play mode that provides bass reproduction with body.

When the subwoofer is set to “YES”, bass sound is output from the subwoofer regardless of the subwoofer mode setting in surround modes other than Dolby/DTS.

35

Image 35
Contents Nous vous remercions pour l’achat de cet appareil ADV-M51Important Notice do not Modify this Product ProductSafety Instructions Table of Contents DVD Surround Receiver Before UsingEnglish Features Playback control video CDs Disc terminology Titles and chapters DVD-videosFollowing types of discs cannot be played on the ADV- M51 CVD SvcdHolding Discs Cleaning DiscsDiscs Connections Connecting the audio components D-M31 seriesADV-M51 DRR-M31 L R Video TV Vedeo OUT Connecting a TVConnection of AM antennas Connecting the antenna terminalsAM loop antenna assembly Connecting a monitor TV Component Video OUT jack Color component output connectors PR/CR, PB/CB and YSpeaker system connections When a disc is played on the ADV-M51 Digital OUTWhen TUNER, LINE-1 or LINE-2 is selected Connecting the speaker cordsRed side is the + side, the black side the side Using the active subwoofer DSW-3L D-M51DVS onlyConnecting banana plugs Removing the speaker net SC-A3L D-M51DVS onlyStop/band button 2 Band Part Names and FunctionsDVD Surround Receiver ADV-M51 Front Panel Display5DVD search buttons Remote control unitTransmission indicator Sleep timer button Input source/surround mode selector button System buttonsSurround Parameter SET UPOFF FunctionDVD system buttons Operated with mode switch 2 set to DVD LF direct switch LF Direct Line input connector LineLine output connector Line OUT Phase selector switch PhaseInserting the batteries Remote Control UnitUsing the remote control unit Tape deck system button Operating Denon audio componentsCD recorder system buttons Codes on pages 26 to TV and video deck preset memoriesPreset memory refer to the tables of remote control Video deck, then input the 3-digit number corresponding toAOC Combinations of preset codes for different brandsNEC VCR STS It may not be possible to operate some models TV system buttonsVideo deck system buttons Operate the video componentCursor buttons Setting UP the SystemSystem setup items System Setup buttonQuick setup procedure 2CH Virtual & SW TV screen size settingSpeaker system settings 2CH VirtualDetailed system setup changing the system settings Assignment of low frequencies Subwoofer modeParameters Subwoofer SW FREQ. frequencyPreparation Delay time distance settingAdjust the channel levels in the test tone mode Adjusting the channel levelLINE-1/LINE-2 REC OUT DVD Auto Power Off settingFunction settings Play Back After changing the system settingsInput function settings LINE-1/LINE-2 analog recording output settingLoading Disc For many interactive DVDs and video CDs with playback This set has the following presettingsPlayback Press the Play buttonStopping Playback Forward / Reverse Searching Playing Still Pictures PausingUnit or the remote control unit Searching using the number buttonsPlayed Input mode settingSlow Playback for DVDs and video CDs only Reverse slow play is not possible on video CDsOn the display Input mode displayAuto mode Volume level is displayedTurning the sound off temporarily Muting Adjusting the sound quality TONE/SDBAfter starting playback Defeat SDB Bass Treble ON/OFFDolby Digital compatible media and playback methods Dolby SurroundDolby Digital Dolby Digital and Dolby Pro LogicDTS compatible media and playback methods DTS Digital SurroundDolby Virtual Speaker Features of Dolby Virtual Speaker soundPlaying in the Dolby Virtual Speaker mode E 0 dB 10 ...-5 Efault Y/NR E F W I DE O M P . O FF OFF LOW MID HIVirtual 1 Virtual Channel mode settingsDolby VS Video Game VIRTUAL1 Virtual 1 modeVIRTUAL2 Virtual 2 mode Playing in the Denon original surround modesRoom Size Efault Y/N YES Y/N noDefault I Z EMD/LINE1 Table of Surround Mode ParametersTone Cinema MUSIC2 MUSIC1 Playback using the Dolby Headphone modeDH1 DH2 DH3 Bypass I N E MARecording Dolby H Dolby Headphone modesChannel modes Listening to the Radio TuningAuto tuning About the tuning mode and the preset mode3 F M 9 2 0 M 3 F M D E N O N M 9 2 0 MM D E N on 3 F M D E N onStart Auto tuner presetsListening to preset stations Status is displayed Remote control for at least 2 secondsPress in the MENU/SET button on the main unit, then press MENU/SET button again for at least 2 seconds whileExample For video and music CDs Operating using the disc information OSDExample For DVDs Adjusting the picture quality Play mode, press the Repeat button Display on the TV screen switches each time the button isPlaying Repeatedly Playing Repeatedly Repeat PlaybackStarts Playing a Certain Section Repeatedly A-B Repeat PlaybackThis sets start point a Press the A-B Repeat button againTracks start playing in the programmed order Playing Tracks in the Desired OrderExample To program tracks 5 Press the Play 1 button Tracks start playing in random order Playing Tracks in the Random OrderTo change the folder MP3 WMA PlaybackListening to Recorded MP3 CD/CD-R/CD-RW Normal Æ Track Repeat Æ Folder Repeat To set the random play modeTo set the repeat mode To change the MP3 fileListening to Recorded WMA Windows Media Audio CD-R/CD-RW Playing Kodak picture CDs Playing still picture files Jpeg formatBeen written into the ADV-M51 Use the and ª cursor buttons on the remote controlEnter button on the remote control unit Load the CD-R/RW on which the still pictures haveSpecial play modes for MP3/WMA and Jpeg files Switching the Audio Language Multiple Audio Function Using the Multiple Audio, Subtitle and Angle FunctionsCurrent subtitle language number is displayed Switching the Subtitle Language Multiple Subtitle FunctionDuring playback, press the Subtitle button Use the and ª cursor buttons to select the desired angle Switching the Angle Multiple Angle FunctionDisplay turns off when the Angle button is pressed Current angle number is displayedUsing the Top Menu Using the MenusDVD Menu Using the DVD MenuUse the cursor buttons ª, , 0 and 1 to move the zoomed Playing in the zoom modePlay or pause mode, press the Zoom button Zoom rate increases each time the Zoom button is pressedM e a M 1 2 Using the TimerSetting the clock 12-hour display Before setting the timerPM1200 Setting the everyday timer and once timerFM 92 M AM1200F f / E o n N P M 1 2F f a M 1 2 F f P M 1 2On light when setting the start time Example 2 Listening to a CD with the once timerNow follow steps 9 to 18 under Setting the everyday timer Once timer pages 82N / E Turning the everyday timer and once timer on and offAbout the everyday timer and once timer Everyday timer and once timer priorityButton again until 50 is displayed Setting the sleep timer remote control unit onlyWhen the Sleep indicator is flashing, press the Sleep Power is set to the standby mode 50 minutes laterAudio Setup Disc SetupOSD Setup Video SetupDisc Setup is selected English Language code list Black When OSD Setup is selectedWall Paper GrayTV Type Video Setup is selectedVideo Mode TV AspectVideo PALMulti FilmPCM Audio Setup is selectedDigital OUT To exit the Lpcm select mode Rating Level PasswordRatings is selected Use the number buttons to input a 4-digit password Slide Show Other Setup is selectedCaptions Use the and ª cursor buttons to set the time When Slide Show has been selectedAuto function selection Auto power on functionSystem Functions Synchronized recording function R 5 3 210 16B0120 R 5 6 0ApeEdit C 01 09A0240About synchronized recording onto the cassette deck DRR-M31 R 0 0 0Initialization of the Microprocessor Last Function MemoryCheck again before assuming the player is malfunctioning TroubleshootingActive TunerSpecifications Input impedance DimensionsRated output power Speakers

ADV-M51, D-M51DVS, ADVM51 specifications

The Denon D-M51DVS, ADVM51, and ADV-M51 are a trio of compact audio systems engineered for audiophiles and casual listeners alike, blending cutting-edge technology with stylish design. These models provide an ideal solution for those who desire high-quality sound without taking up excessive space in their homes.

At the heart of the D-M51DVS is its 2.1-channel amplifier configuration, delivering a robust yet nuanced sound that can fill any room. The system is equipped with an integrated CD player, radio tuner, and Bluetooth connectivity, allowing users to enjoy their favorite music from multiple sources. It supports various audio formats, ensuring versatility in playback options.

One of the standout features of the Denon D-M51DVS is its advanced digital signal processing technology. This feature enhances audio performance, providing clear highs, rich mids, and deep bass, creating an immersive listening experience. The system also boasts a power output of 30 watts per channel, making it suitable for both small and medium-sized spaces.

The ADVM51 and ADV-M51 models share similar sleek aesthetics with a user-friendly interface. They incorporate a high-quality DAC (Digital-to-Analog Converter) that ensures accurate audio reproduction, thus maintaining the integrity of recordings. The systems are designed to minimize distortion, which is crucial for listeners who appreciate the subtleties in music.

With connectivity at the forefront of modern audio systems, the Denon D-M51DVS, ADVM51, and ADV-M51 offer multiple inputs, including USB and auxiliary options, allowing seamless connection to smartphones, tablets, and computers. This versatility makes it convenient for users to switch between their favorite music sources without hassle.

Additionally, these systems are built using premium materials, contributing to their durability and long-lasting performance. The contemporary design fits well in any decor, making them a stylish addition to any room.

In conclusion, the Denon D-M51DVS, ADVM51, and ADV-M51 represent a commitment to high-fidelity audio in a compact form factor. With impressive features, advanced technology, and attractive aesthetics, they cater to diverse listening preferences, making them an excellent choice for music enthusiasts. Whether for casual listening or serious audiophile pursuits, these systems deliver on quality and versatility, making them worthwhile investments for anyone looking to elevate their audio experience.