Denon ADV-M51 manual Adjusting the channel level, Adjust the channel levels in the test tone mode

ENGLISH

[3] Adjusting the channel level

•Adjust so that the playback levels of the different channels are equal.

•Make this adjustment by listening to the test tones output from the speakers at the listening position.

•By factory default all the levels of all the channels are set to 0 dB.

•This adjustment can also be made directly from the remote control unit. (CH SELECT Button)

1	If you are not at the system setting changing menu screen,	6	q When “Auto” is selected at “Test Tone”:
	read step 1 and 2 on page 34.
2	At the system setting changing menu screen, use the 0 and		CHANNEL LEVEL
			TEST TONE MODE	AUTO	MANUAL
	1cursor buttons to select “Channel Level Adjustment”, then
			LEVEL CLEAR
	press the ENTER button.
			TEST TONE START YES
			FRONT L	0dB
			FRONT R	0dB
	ENTER		SUBWOOFER	0dB
			SELECT :	FINISH : ENTER BUTTON

Remote control unit Remote control unit

•The channel level adjustment screen appears.

CHANNEL LEVEL
TEST TONE MODE	AUTO	MANUAL
LEVEL CLEAR
TEST TONE START
FRONT L	0dB
FRONT R	0dB
SUBWOOFER	0dB
SELECT :	FINISH : ENTER BUTTON

3	Use the 0 and 1 cursor buttons to
	select “Auto” or “Manual” for the

“Test Tone” mode.

• The selected setting is displayed in yellow.

Remote control unit

BAuto: Adjust the levels listening to test tones automatically output from the different speakers.

BManual: Select the speakers from which the test tones are output when adjusting the levels.

	Detailed settings can be made when this is set to
	“Manual” first.
4	When “Yes” is selected at “Level Clear”, the level settings
	for all the speakers are set to 0 dB.

BYes: The level settings for all the speakers are set to 0 dB.

BNo: The currently set level settings are retained.

5	Adjust the channel levels in the test tone mode.
	Use the • and ª cursor buttons to select the “Test Tone

Start” mode, then use the 0 cursor button to select “Yes”. The test tone is output.

Use the MASTER VOLUME control on the main unit or the VOLUME buttons on the remote control unit to adjust the volume of the test tone to a level at which it is easy to make this adjustment.

•Test tones are automatically output from the speakers at intervals of 4 seconds for two of the cycles shown below, then at intervals of 2 seconds from the third cycle on.

Front left Front right

Subwoofer

Use the 0 and 1 cursor buttons to adjust the channel levels so that the volume of the test tones output from the different speakers sounds the same.

•The level changes in units of 1 dB each time the 0 and 1 cursor button is pressed.

The level can be adjusted in the range –12 dB to +12 dB.

wWhen “Manual” is selected at “Test Tone”:

CHANNEL LEVEL

TEST TONE MODE AUTO MANUAL

LEVEL CLEAR

TEST TONE START YES

FRONT L	0dB
FRONT R	0dB
SUBWOOFER	0dB
SELECT :	FINISH : ENTER BUTTON

Use the • and ª cursor buttons to select the speaker from

which the test tone is to be output, then use the 0 and 1

cursor buttons to adjust the channel levels so that the volume

of the test tones output from the different speakers sounds

the same.

•The level changes in units of 1 dB each time the 0 and 1 cursor button is pressed.

The level can be adjusted in the range –12 dB to +12 dB.

37