INSTALLATION
NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation.
Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual.
WARNING:
PERSONAL INJURY RISK
Installation procedures must be performed by a qualified technician with full knowledge of all applicable electrical and plumbing codes. Failure can result in personal injury and property damage.
WARNING:
ELECTRIC SHOCK HAZARD
All servicing requiring
access to
DO NOT open any access panel which requires the use of tools. Failure to
follow this warning can result in severe electrical shock.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective plastic film, packing materials and accessories from the Appliance before connecting electrical power or otherwise performing any installation procedure.
Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the appliance before starting any installation.
Read and understand all labels and diagrams attached to the appliance.
Carefully account for all components and accessories before discarding packing materials. Store all accessories in a convenient place for later use.
COMPONENTS
1 - 4 ea. DRAWERS (qty. depends on model)
1 - 4 ea. HUMITROL RACKS (if ordered with unit)
FABRICATION
Refer to INSTALLATION INSTRUCTIONS for cutout dimensions and support fabrication information.
1.Layout front panel cutout dimensions. Cut hole in counter front panel.
2.Position supplied mounting flange in hole to determine hole location. Drill hole using #34 drill.
3. Attach flange to front panel using the provided #6 screws.
4. Fabricate rails and rear support as shown in instructions.
INSTALLATION
Refer to electrical specifications on page 1. Circuit must meet or exceed the amperage and wattage requirements listed.
1.For ease of installation, remove drawer from unit.
2.Slide unit through front panel opening until rear of unit rests on the rear support.
3.Remove TEMPERATURE CONTROL KNOB and CONTROL PANEL.
4.Install provided
5.Connect power leads (including ground lead). Wiring or conduit must be secured to the warmer with a suitable strain relief (provided by electrical installer).
6.Reinstall CONTROL PANEL and TEMPERATURE CONTROL KNOB.
4