ENGLISH
TROUBLESHOOTING
Check the following once more before assuming there is a problem with the system.
1.Are connections proper ?
2.Is the system being operated as explained in the operating instructions ?
If the system does not seem to be operating properly, check as shown on the table below. If none of these checks apply to the problem, the system may be malfunctioning. Disconnect the power cord immediately and contact your store of purchase.
| Symptom |
| Cause | Countermeasure | Page | ||
|
|
|
|
| |||
General | Power does not turn on when | • Power cord is not plugged into a | • Plug the power cord securely into | 14 | |||
power operation switch is | power outlet. | an outlet. |
| ||||
pressed. |
|
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
| • Antenna direction is poor. | • Change the direction of the | 13 | |
| Hissing sound is heard in FM |
| antenna. |
| |||
| broadcasts. |
|
| • Signals from the broadcast station | • Install an outdoor antenna. | 13 | |
|
|
|
| are weak. |
|
| |
section |
|
|
|
|
|
| |
|
|
| • Noise from a TV or interference | • Turn the TV off. | – | ||
Hissing sound is heard in AM | from a broadcast station. |
|
| ||||
| • Change the direction of the loop | – | |||||
broadcasts. |
|
|
| ||||
Tuner |
|
|
| ||||
|
|
| antenna. |
| |||
|
|
|
|
| |||
|
|
|
| • Install an outdoor antenna. | 13 | ||
|
|
|
|
|
|
| |
|
|
|
| • Signals on the power cord are | • Insert the power cord in the | – | |
| Humming sound is heard in | being modulated by the power | opposite direction. |
| |||
| AM broadcasts. |
| source frequency. |
|
| ||
|
|
|
|
| • Install an outdoor antenna. | 13 | |
|
|
|
|
|
|
| |
|
|
|
| • Disc is loaded | • Reload the disc. | 12 | |
| Total number of tracks not | • Disc is dirty. | • Clean the disc. | 19 | |||
| displayed when disc is loaded. | • Disc is not of the specified type. | • Replace with a disc of the specified | – | |||
|
|
|
|
| type. |
| |
|
|
|
|
|
|
| |
| Nothing | happens | when | • Disc is loaded | • Reload the disc. | 12 | |
| • Foreign object on disc tray. | • Remove the disc and the foreign | – | ||||
section | operating buttons are pressed. | ||||||
| object. |
| |||||
Disc stops in the middle of a |
|
| |||||
• Disc is dirty. | • Clean the disc. | 19 | |||||
track and will not play properly. | |||||||
• Disc is scratched. | • Replace with an unscratched disc. | – | |||||
player |
|
|
| ||||
|
|
|
|
|
| ||
|
|
| • Dirt, fingerprints, spittle, etc, on | • Clean the disc. | 19 | ||
CD |
|
|
| ||||
|
|
| disc. | • Replace with an unscratched disc. | – | ||
| Sound is broken. |
| • Disc is scratched. | ||||
|
|
|
| • Player is in an unstable place and | • Place the player in a stable place | – | |
|
|
|
| vibrated strongly. | with no vibrations. |
| |
|
|
|
|
|
|
| |
| Humming | sound is | heard, | • Signals on the power cord are | • Insert the power cord in the | – | |
| being modulated by the power | opposite direction. |
| ||||
| when disc is played. |
|
| ||||
|
| source frequency. |
|
| |||
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
23