Cambridge SoundWorks PCWorks manual Attaching The Desktop Stands Attaching The Floor Stands

Page 10

Attaching The Desktop Stands

Attaching The Floor Stands

For most applications, the satellite speakers should be used with their desktop stands. Install each stand by inserting it into the “T” shaped socket in the back of each satellite. Make sure to feed the wires through the cut-out in the top of the desktop stands (see diagram C).

For desktop placement, apply the five self adhesive feet to the base of the desktop stands. If you wish to install the rear satellites in the floor stands, do not apply the self adhesive feet to the base of their desktop stands (see diagram D).

The rear satellites (with their desktop stands attached) may be installed in their floor stands.

1. One leg of each floor stand

has a full length slot, with

short notches opposite the

slot at each end. Insert a

satellite cable inside one of

these legs by feeding it down

the length of the full length

3.

Insert the two solid legs into

 

the outside sockets in the

 

apex joint.

4.

Slide the back of the satellite’s

 

desktop stand into the front of

 

the slot in the apex joint. The

 

slot’s front is the side further

 

away from the rear leg socket.

 

Make sure the stand is

 

securely pressed into the slot

C

D

slot. At each end, feed the

cable through the short

notches (see Diagram E).

2. Ensure there are no feet

attached to the satellite’s

desktop stand. Insert the

satellite end of the leg/cable

assembly into the middle

socket of the apex joint. Make

sure the satellite cable exits

through the short notch and

not the full length slot (see

Diagram F).

(see Diagram F).

5. At the base of the rear leg,

gently pull on the satellite

cable to remove any unneces-

sary slack in the cable.

6. Insert a rubber plug into the

base of each leg, taking care

to feed the cable out the short

notch in the rear leg (see

Diagram G).

E

6

Image 10
Contents PCWorks FourPointSurround Avis Important Safety Instructions Contents Introduction Cambridge SoundWorksOverview Installation Sequence Volume Control with 12 ft. audioSpeaker Placement Speaker Wiring Diagram CambridgeSatellite Connections Attaching The Desktop Stands Attaching The Floor Stands Power Supply Adapter Volume Control LineMounting The Volume Control Adjusting Output Level ControlSubwoofer Level Control Playback LevelsTo a flat surface Optimizing The Sound Mounting The Satellites Your SystemTo the wall Technical Support SpecificationsInside U.S.A., Canada and Latin America Inside Europe FranceYear Limited Warranty Inside AsiaPage Needham Street, Newton, MA