Rival GC9155-CN manual Freezer Bowl Fig, Base, Into place Fig, Properly, Ingredient Chute

GC9155CN06EFM1.qxd 2/16/06 09:07 Page 4

BEFORE YOU USE YOUR ICE CREAM MAKER

HOW TO USE YOUR ICE CREAM MAKER (CONT.)

Wash all parts according to the “HOW TO CLEAN YOUR ICE CREAM MAKER” section in this manual.

1. To assemble the ice cream maker, slide the Motor

Unit into the Cover until it locks into place; the

tabs underneath will "click" when secured (Fig. 3).

FIGFig. .7 4

PREPARING THE FREEZER BOWL

Your Ice Cream Maker features a double insulated Freezer Ring and space-saving Freezer Bowl that require thorough freezing before use. Remove the Sealing Ring from the bottom of the Freezer Ring. Place the Freezer Bowl inside the Freezer Ring (Fig. 2), wrap them in a plastic bag, and store them upright in the back of your freezer where the temperature is the coldest.

Wrapping your Freezer Bowl and Freezer Ring, in a plastic bag, will guard against freezer burn. For optimal freezing results, we recommend a minimum freezing period of 24 hours.

NOTE: Storing the Freezer Bowl and Freezer Ring in the freezer will ensure you are ready to make ice cream on short notice.

HOW TO USE YOUR ICE CREAM MAKER

Your ice cream maker can make up to 1.5 quarts of ice cream. Due to an increase in volume during preparation, the maximum amount must not exceed 1 quart of liquid.

NOTE: It is extremely important that you prepare the ice cream mixture before you remove the Freezer Bowl and Freezer Ring from the freezer. Both the Freezer Bowl and the Freezer Ring must be used immediately when you remove them from the freezer, or they will begin to thaw which will jeopardize making/freezing the ice cream.

FIG. 2

FIG. 3

2.	Insert the Mixing Paddle into the Motor Opening
	(Fig. 4).
3.	Remove the Freezer Bowl and Freezer Ring from
	freezer.
4.	Place the Sealing Ring onto the bottom of the
	Freezer Ring (Fig. 5). NOTE: Always use this
	Sealing Ring when making ice cream to ensure a
	tight seal between the Freezer Ring and Freezer
	Bowl.
5.	Slide the tabs on the top of the Freezer Bowl into
	the underside of the Freezer Ring. Rotate the
	Freezer Ring counter-clockwise and lock it onto
	the Freezer Bowl (Fig. 5).
6.	Place the Freezer Bowl assembly into the Freezer
	Base (Fig.6).
7.	Place Cover assembly onto the Freezer Base and
	turn the Cover counter-clockwise until the tabs lock
	into place (Fig. 7).
8.	Insert the plug into a wall outlet and immediately
	press the switch to the ON position.
	NOTE: Unit must be operating before ice cream
	mixture is added because ice cream will begin to
	freeze and the Mixing Paddle will not operate
	properly.
9.	Pour the prepared ice cream mixture through
	Ingredient Chute.

10.Allow the Ice Cream Maker to run until the mixture reaches the desired consistency. Do not turn the

FIG. 5

FIG. 6

FIG. 7

Fig. 8

-E4- -E5-