Fig 1 | Keep excess cable |
behind or under the | |
| dashboard |
•For best FM Modulator performance, you must locate the satellite radio antenna in a location that is in close proximity to the vehicle'sFM antenna.
•Avoid kinking, crimping, twisting or chafing the cable. Use
•For option 1 and rear mounting locations, route the cable into the trunk as shown. Always cross the weather seal at the lowest part of the trunk to reduce water leaks. From the trunk, route the cable into the passenger compartment through available wire channels and then along the floor under the door jam trim or under the carpet to the front of the passenger compartment. Do not leave the cable loose in the passenger compartment where it is likely to be damaged.
•For option 2 and front mounting locations, route the cable along the door jam and into the vehicle as shown. Route the cable across the weather seal near the bottom of the door to reduce water leaks.
Be sure to locate your car cradle and receiver below the top of the dash in your vehicle to keep the product within easy reach while driving. Choosing a lower location in your installation should also make it easier to manage the cables and achieve a more desirable appearance when the installation is completed. A lower location for the receiver in the vehicle will ensure that the installation does not cause interference with other FM radios outside the vehicle.
See illustration below (Fig 2) and be sure to locate your car cradle within the shaded area.
Fig 2