Preparing for Use (Cont.)
Skewers
NOTE: Use Skewers with the Rotisserie Bar Assembly only. Do not attempt to use Skewers in any other manner.
1.Load food onto the skewers.
2.Place the End Wheel with
Thumb Screw onto the center bar of the Rotisserie Bar Assembly. Align the locking device on the End Wheel with the guide lines on the center bar of the Rotisserie Bar Assembly. Tighten thumb screw to lock in place.
3.Hold one Skewer with the hooked end of the Skewer fac- ing to the left. Place the Skewer in a notched cut out in the End Wheel with Thumb Screw and align the tip of Skewer with the
hole in the raised tab on the End Wheel (with gear).
4.Squeeze and press down on the top of the Skewer until it snaps firmly into place. See Figure 7. Repeat for remaining Skewers.
5. WITHOUT TURNING THE ROTISSERIE ON YET, use the Cover Handles to raise the Cover.
6. Hold the Rotisserie Bar Assembly so the End Wheel with the gear faces to the right. Slide the Rotisserie Bar into the Rotisserie along the Rotisserie Bar Assembly Track. Make sure each end of the Rotisserie Bar Assembly drops into the center grooves of the Rotisserie Bar Track.
THUMB SCREW
GUIDE
LINES
Figure 6
NOTCHED
WHEEL
HOOKED END
OF SKEWER
"SQUEEZE"
Figure 7
14