Note: To determine which screws to use, you must have enough of the screw exposed underneath the cabinet to properly thread the screw into the nut.
11.Screwing from inside the cabinet down into appliance holes, tighten 4 screws in place to secure appliance to cabinet.
Note: Always tighten screws to ensure the appliance does not move or shake during operation.
12.Pull out cord from cord storage behind appliance and plug into standard electrical outlet. Extra cord can be fed back into storage or hung over cord management hook behind unit (F).
4.After measuring the overhang molding thickness as shown in Illustration G, look at the dashed lines on the mounting template; each line has a measurement next to it that indicates the thickness of the overhang molding used with that line. For example, if your cabinet has an overhang molding thickness of ½”, you will use the ½” dashed line on the template.
5.Fold the template along the dashed line that matches the thickness of your overhang molding.
6.Place the folded template against the back edge of the overhang molding, making sure the side with the drill hole marks is facing down (H).
F
Note: If you are connecting this appliance to the receptacle of another †SpaceMaker™ appliance such as the toaster oven or coffeemaker, make sure you can easily unplug the appliance following use.
13. Your †SpaceMaker™ appliance is now ready for use!
OVERHANG MOLDING INSTALLATION
For cabinets with an overhang molding (see Illustration C)
Important: Always wear protective glasses or goggles to prevent injury when drilling.
Note: Spacers are provided in case your cabinet has an overhang molding at the front edge. Only use spacers on the rear screws of the appliance to ensure it is level with the front.
1.Clear countertop under installation area to avoid getting dust or debris on other appliances or items. Open cabinets and remove contents to make mounting easier.
2.Clean both the underside and topside of the bottom panel of the cabinet.
3.Using a ruler, measure the thickness of the overhang molding (G), accurately noting the number for use in the following step.
G
Note: If you do not have a ruler, you may cut out the paper ruler provided on the edge of your mounting template.
H
Important: Do not align screw holes on template directly under the partition between cabinets, as this will prevent you from installing the appliance properly. Pay close attention to where the drill holes will be set so as not to damage your cabinets during mounting. Drilling through your cabinet’s partition may cause damage to cabinets and prevent proper installation.
7.Making sure to keep the fold line straight against the back edge of the overhang molding, tape the template securely in place.
8.Drilling from under the cabinet up, drill holes through the 4 places marked on the template using a
J
Important: Always ensure you are drilling straight up through the marked mounting holes on the template. Drilling at an angle may prevent proper installation and may damage cabinets if the drill bit pierces the partition.
9.Once holes are drilled, remove tape and mounting template.
10.Wipe dust and debris off the underside and topside of the cabinet surface.
11.Place a washer inside the cabinet over each of the 4 holes you drilled.