MRC88 / MRAUDIO8X8 QUICK START GUIDE | 13 |
IR EMITTERS
Use the 8 included 283M Emitters for IR control of common source components.
1.Locate the IR sensor on the device to be controlled. If the sensor is not obvious, shine a small flashlight into the device front panel display to locate the sensor or refer to the product manual for that device.
2.Remove the adhesive protective cover on the flat side of the emitter and attach the emitter over the IR sensor on the front panel of the source to be controlled via IR.
3.Carefully pull the emitter wire around to the back of the unit. Do not block disc and tape accesses. Do not pinch the wire between components.
4.Plug the emitter into the appropriate source IR Emitter Output on the MRC88 rear panel.
5.Repeat for all sources to be controlled via IR.
Figure 10 – IR Emitter Connection
08905142A