Frymaster BIRE14, MRE14 warranty General Installation Requirements

Page 11

BIRE14/MRE14 SERIES E4 ELECTRIC FRYER

CHAPTER 2: INSTALLATION INSTRUCTIONS

2.1General Installation Requirements

Proper installation is essential for the safe, efficient, trouble-free operation of this appliance.

Qualified, licensed, and/or authorized installation or service personnel, as defined in Section 1.6 of this manual, should perform all installation and service on Frymaster equipment.

Failure to use qualified, licensed, and/or authorized installation or service personnel (as defined in Section 1.6 of this manual) to install or otherwise service this equipment will void the Frymaster warranty and may result in damage to the equipment or injury to personnel.

Where conflicts exist between instructions and information in this manual and local or national codes or regulations, installation and operation shall comply with the codes or regulations in force in the country in which the equipment is installed.

Service may be obtained by contacting your local Factory Authorized Service Center.

NOTICE

All fryers shipped without factory supplied cords and plug assemblies must be hardwired using flexible conduit to the terminal block located on the rear of the fryer. These fryers should be wired to NEC specifications. Hardwired units must include installation of restraint devices.

DANGER

Adequate means must be provided to limit the movement of this appliance without depending on or transmitting stress to the electrical conduit. A restraint kit is provided with the fryer. If the restraint kit is missing contact your local Frymaster Factory Authorized Service Center (FASC) for part number 826-0900.

NOTICE

If this equipment is wired directly into the electrical power supply, a means for disconnection from the supply having a contact separation of at least 3-mm in all poles must be incorporated in the fixed wiring.

NOTICE

This equipment must be positioned so that the plug is accessible unless other means for disconnection from the power supply (e.g., a circuit breaker) is provided.

NOTICE

If this appliance is permanently connected to fixed wiring, it must be connected by means of copper wires having a temperature rating of not less than 167°F (75°C).

2-1

Image 11
Contents 8196151 Canada Page Warranty Statement Parts Return This page Intentionally Left Blank General Safety InformationDefinitions Computer Information for the M2000 ComputersEuropean Community CE Specific Information What to do if your equipment arrives damaged Shipping Damage Claim ProcedureService Information General Installation Requirements Page Power Requirements Page BIRE14/MRE14 Series E4 Electric Fryer Operating Instructions Operation Equipment Setup and Shutdown ProceduresIntroduction Do not USE Filter Powder with the PAD Turn the filter handle to the on position Page Clean Behind Fryers Weekly Fryer Clean Detachable Parts and Accessories WeeklyAnnual/Periodic System Inspection Built-In Filtration System Introduction Troubleshooting Computer and Heating Problems Problem Probable Causes Corrective ActionCorrective Action D. If the circuitry in the fryer ProblemCelsius Error Messages and Display ProblemsFailure Shows HI 2 BADFailure with Start Filtration ProblemsProblem This page Intentionally Left Blank Service Hotline