Frymaster II operation manual Programming the Batch Weight Selectors

The indicator light in the selector will illuminate and the drum will begin to rotate, transferring fries from the hopper to the dispensing chute. When the prescribed weight has been transferred, drum rotation will cease.

12.Insert an empty basket all the way to the rear of the dispensing chamber. The dispensing chute door will open, dropping the fries into the basket. When the chute is empty, the door will close and the unit will begin to transfer another batch of fries into the chute.

CAUTION

The dispensing of fries into a basket is initiated by an inductive proximity switch located in the dispensing well. The proximity switch activates only when it senses a metallic mass greater than a certain size (e.g., an inserted basket). Thus, it will not be activated by the operator’s hand, a cleaning cloth, or any other non-metallic object. However, a ring, watch or some other type of metal could initiate a dispense cycle if inserted into the switch detection area.

NOTE: Built-in logic recognizes the removal and replacement of the basket. Once a dispense cycle has been completed, another basket may be inserted into the dispense well. As soon as the fries in the chute reach the specified weight, the unit will immediately dispense them into the waiting basket. The unit will NOT initiate another dispense cycle if the full basket is not removed and replaced, nor will it initiate another dispense cy- cle if there is no basket in the dispense well.

To change the batch weight, press another of the numbered selectors before the chute is emptied. If the weight is increased, fries will be dispensed until the new weight is attained. If the batch weight is reduced, the change will take effect with the next cycle after the dispensing chute is emptied.

If the dispensing chute does not fill within 30 seconds, the CHECK HOPPER indicator in the middle of the control panel will begin to blink and drum rotation will stop. Check the hopper to see if

it is empty. If it is empty, reload the hopper then press the PROGRAM Switch once to place the unit back into operation. If the hopper appears to contain plenty of fries, the fries have probably “bridged” (i.e., stuck together to form an arch over the drum). Redistribute the fries then press the PROGRAM

Switch once to place the unit back into operation.

2.4Programming the Batch Weight Selectors

The four Batch Weight Selectors in your SinBaD are factory programmed with four standard batch weights (see page 2-3). If desired, they can be reprogrammed to dispense batch weights ranging from a minimum of

.38 lb/.23 kg up to a maximum of 2¼ lbs/1 kg.

CAUTION

Programming the unit for weights less than .38 lb/.23 kg will result in erratic batch weights.

The PROGRAMMING mode can only be entered when the unit is in STANDBY mode. To enter the STANDBY mode, press the RUN Switch once. Verify that the indicator light in the Switch is out. If not, press the RUN Switch again.

1.Remove the hopper assembly from the unit. NOTE: If the hopper is not empty, refer to Section 3.1 for instructions on emptying the hopper.

2.Press the PROGRAM Switch once to enter the PROGRAMMING mode. The indicator light in the switch will blink. Press BATCH WEIGHT Selector 1 four times. The indicator lights in each of the selectors will light in sequence until all four are lit, at which time the indicator in the PROGRAM Switch will stop blinking and the indicator in the CLEAN Switch will blink.

2-4