Frymaster 2836 manual Replacement element. Ensure the pin

7.Install the replacement element in the frypot and secure with the mounting hardware.

8.Reinstall the temperature probe and probe-bracket components onto the replacement element.

9.Route the element leads (terminals) to the rear of the fryer

10.Secure element wiring with wire-ties.

11.Route the element wires through the conduit and tighten conduit connector.

11. When replacing the left element (as viewed from the rear of the fryer), use the 9-pin

connector, inserting the leads from the	Ensure that the wires are properly routed and
replacement element. Ensure the pin
numbers match the numbers of the defective		secured.
element wires. When all pin terminals have
been fully inserted, close the connector by
sliding the halves together until the tabs snap
back into place (reverse procedure in this
section, Step 2). Check wire numbers to
ensure correct wiring of the replacement
element.
When replacing the right element (as viewed
from the rear of the fryer), follow the above
procedure, inserting pin terminals into the
corresponding holes in the 6-pin connector.	Left Element—	Right Element—
12. Connect the connectors, ensuring the latches	9-Pin Connector	6-Pin Connector

lock in place.

13. Install the temperature probe wires (marked for re-assembly) in the corresponding pin locations.

14. Reconnect the element springs to the tilt brackets

15. Install the back covers, basket lift assembly, and top cap and secure with screws.

16. Position fryer under exhaust hood.

1-5