Frymaster 2836 manual Replace Heating Element

9.Remove the probe bracket and the securing components from the probe bulb and element. Thread the probe wire through the hole in the tilt plate assembly and remove the probe.

10.Thread the new probe wire through the hole in tilt plate. Place the new temperature probe

assembly onto		element and secure with the bracket and screws removed earlier. Clip the
probe	the	of the element in two places. The temperature probe assembly should be
oriented in		same manner as the probe being replaced.

11.Thread the probe wires into the harness insulation. Note the pin positions and insert pins in the connector. Reconnect the harness and secure with a wire-tie.

12.Lower the element into the frypot with the lift handle.

13.Install the back covers, basket lift assembly, and top cap and secure with screws.

1.6 Replace Heating Element

1. Perform Procedure 1.5, Replace Temperature Probe, Steps 1-7.

2. Unplug the element connectors for the				Harness				Harness
element being removed (right element- 6-pin			Connector				Connector
				Closed					Open
harness connector; left element- 9-pin harness						Top Portion
connector). Remove the element wires from
the connector. Press down on either side of
the connector while pulling up on the top
portion. The connector will open from the
top. Note wiring configuration in connector
before removing element wire pins. Pull all	Push in on tabs to release
wires from the connector.		top portion
3. Loosen conduit connector and pull element
wires through conduit.
4. Remove the screws securing the temperature
probe bracket from the element. Remove the
probe clamp (metal wire-wrap). Set the
temperature probe and probe-securing
components aside.
NOTE: Temperature probe removal is not					Loosen connector here.
required if the left element is being replaced.

5.Disconnect the element springs from the tilt brackets.

6.Remove the element clamps and hardware before removing mounting-screws and nuts on the defective element. Remove all wire-ties securing element wiring, and then remove element from frypot.

1-4