Frymaster 2836 manual

Page 3

DANGER

This appliance must be connected to the voltage and phase as specified on the ratings and serial number plate located on the inside of the fryer door.

WARNING

Do not attach accessories to this fryer unless the fryer is secured from tipping. Personal injury may result.

WARNING

Do not use water jets to clean this equipment.

WARNING

This equipment is intended for indoor use only. Do not install or operated this equipment in outdoor areas.

DANGER

Adequate means must be provided to limit the movement of this appliance without depending on or transmitting stress to the electrical conduit. A restraint kit is provided with the fryer. If the restraint kit is missing contact your local Frymaster Dean Factory Authorized Service Center (FASC) for part number 826-0900.

DANGER

Prior to movement, testing, maintenance and any repair on your Frymaster fryer, disconnect all electrical power from the fryer.

DANGER

The front ledge of the fryer is not a step. Do not stand on the fryer. Serious injury can result from slips or contact with the hot oil.

DANGER

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

DANGER

The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the end of frying operations each day. Some food particles can spontaneously combust if left soaking in certain shortening material. Additional information can be obtained in the filtration manual included with the system.

WARNING

No structural material on the fryer should be altered or removed to accommodate placement of the fryer under a hood. Questions? Call the Frymaster Dean Service Hotline at 1-800-551-8633.

WARNING

Do not bang fry baskets or other utensils on the fryer’s joiner strip. The strip is present to seal the joint between the frypot. Banging fry baskets on the strip to dislodge shortening will distort the strip, adversely affecting its fit. It is designed for a tight fit and should only be removed for cleaning.

Image 3
Contents Hour Service Hotline Series Electric Fryers Service and Parts ManualCanada Page Table of Contents Parts List Contactor Box Component BoxGeneral Replace Computer/ControllerReplace Interface Board Replace Transformer Replace Temperature ProbeReplace Heating Element Replacement element. Ensure the pin Replace Frypot Replace High-LimitReplace Contactor Latching or Heating Built-in Filter System Service ProceduresSediment Particle Oil Flow Up for reverse Down for forward Basket Lift Service Procedures Simplified Schematic BINDING/JAMMING Problems Diagnostic LED Legend Electric Interface Board Diagnostic ChartProbe Resistance Chart Probe Resistance ChartWiring Diagrams, Main 208/240V Wiring Diagrams, Main 480V 120 V Controls Wiring Diagrams, Main FP28DV/36 480V 120 V Controls Wiring Diagrams, Modular Basket Lifts Wiring Diagrams 208/240V Systems With Built-in Filtration Wiring Diagrams 480V Systems With Built-in Filtration Accessories Series Electric Fryers Parts ListBasket Lift Assembly Modular and Related Components Basket Lift Assembly Modular and Related Components Basket Lift Assembly Modular and Related Components Page 1.1 FP228 Cabinet and Related Components 1.2 FP128/136 Cabinet and Related Components 1.2 FP128/136 Cabinet and Related Components 1.3 FP128/236 Cabinet and Related Components Cabinet Assembly FP128/236 use 106-5891 for FP128DV/236S Door Components Dump Station Components Computer and Related Components Contactor and Power Cord Box Assembly Part Number Terminal Block Mount Assembly Component Box Assembly Component Box Assembly Filter Pan and Related Components Built-in Filtration Handle, Drain Valve Use 230-0892 for FP14 FP28DV Drain Components Elements and Related Components References Previous models Oil Disposal Wand Oil Return Assembly Return Assembly Filter Pump Assembly Part Number Description Basket Lift Harnesses Wiring Harnesses and CablesThis page Intentionally Left Blank Service Hotline