Wegener Communications DVR395, DVR396 manual Warranty

Page 3

Page 3

CAUTION

RISK OF ELECTRIC

SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION

As this unit is intended to interface with other electrical/electronic systems, proper engineering practices must be adhered to during installation and check- out.

All AC power and ground must be installed in accordance with National Electric Code Standards as to conductor size and limitations (see NFPA 70, articles 200- 280, as amended, if required), and lightning protection must be provided.

All RF interconnections must be properly shielded to prevent ingression or egression of potential interfering sources to existing services.

Any damage to this unit caused by improper wiring/interconnections will void any warranty extended.

WARRANTY

The following warranty applies to all Wegener Communications products.

All Wegener Communications products are warranted against defective materials and workmanship for a period of one year after shipment to customer. Wegener Communications' obligation under this warranty is limited to repairing or, at Wegener Communications' option, replacing parts, subassemblies, or entire assemblies. Wegener Communications shall not be liable for any special, indirect, or consequential damages. This warranty does not cover parts or equipment which have been subject to misuse, negligence, or accident by the customer during use. All shipping costs for warranty repairs will be prepaid by the customer. There are no other warranties, express or implied, except as stated herein.

Page 3 of 30

DVR395/DVR396-002

Image 3
Contents Wegener R Communications Digital Video ReceiverThis Page Intentionally Left Blank DVR395/DVR396-002 Warranty This Page Intentionally Left Blank DVR395/DVR396-002 Other Viewing Methods Table of ContentsAbout this Manual Cross-referencesThis Page Intentionally Left Blank DVR395/DVR396-002 Table of Contents List of Illustrations List of TablesList of Cautions & Warnings Physical Environment Section General InformationIntroduction Unpacking and InspectionElevated Operating Ambient Equipment Specifications ParameterRear Panel Connections Ferrite Bead Installation For DVR396Connector Ferrite Size Ferrite InstallationRearDVR396 Panel DVR395 Rear PanelSecurity Labels DVR395/DVR396 Interconnect Descriptions Signal ConnectorRJ-12 DB-9 Female DB-25 Male PIN Signal TX Data RX Data GroundSerial Port DVR395 Serial Cables To Terminal or PrinterManuals To return a product for serviceService@wegener.com Technical SupportControl DIP Switch Functions Mode Setup Functions Section Power on ProceduresControl DIP Switches Front Panel Controls and IndicatorsDVR395 Front Panel Front Panel Controls and Indicator Description LED & ALARM/WARNING ConditionsGreen LED Indications Mode Condition Status LEDRED AmberWelcome Banner Power on ProcedureThis Page Intentionally Left Blank DVR395/DVR396-002 Section Setup On Screen Display OSDSelect And Enter Key Functions Transport Customizing Settings for Your SystemFor Carrier Select Carrier SelectFor Signal Strength For Carrier StatusFor Serial Port Select Software Select For Software VersionAppendix a RMA Request Form Service@wegener.com Date of Change Rev Level Description of Change Record of RevisionsEmail service@wegener.com