XM Satellite Radio SRXM-001 manual Powering UP the System, Selecting a Satellite Channel

Functional Operation

Functional operation of the system is controlled by the buttons on the SCU; i.e., the sequence in which they are pressed, and the length of time button activation occurs.

POWERING UP THE SYSTEM

After the system has been properly installed and activated, the system can be powered on in the following manner:

1.Turn on the existing vehicle radio and tune the radio to the selected FM frequencies between 88.1MHz and 89.3MHz; if you are not sure which frequency to select on your existing radio, use the existing radio’s SEEK, SCAN or TUNE function to tune through the frequencies until the satellite signal is played through the speakers.

1	2	3	1	2	3
4	5	6	4	5	6
7	8	9	7	8	9
			LOADING
	0			0
	SFT			SFT

The Audiovox Logo Appears-and-XM®Satellite Program is Loaded

4.After program loading is complete, the display reverts to either preview channel 001 (if the system is being activated for the first time), or it will return to the last XM®channel being used when the system was turned off. A typical channel display will appear as shown below.

CHANNEL LABEL

ARTIST

NOTE: The default FM frequency is 88.5MHz.

2.Enter this frequency into memory using one of the preset but- tons on the existing radio, making a note of the FM band and preset number.

SONG TITLE			1	2	3
	Planet Groove		4	5	6
	The J Rebal Band		7	8	9
	I Don’t Work Here Anymore
	-----------------------			0
	CH 022	Pop

SFT

OPEN CAR COMPACT DISC PLAYER

P-950

					TRACK
					CH	EQ	ROCK
MUTE					LOC			Tune
	Audio					ST	CLAS
							POP	/Seek
	Control
							LOUD	/Track
LOUD	DISC RND
	RPT					Sub. W
	SCAN
	MULTI-COLOR FLUORESCENT DISPLAY			POWER LEVEL METER
EQ	T/F AS/PS
SEL	1 TOP	2 SCN	3 RPT	4 RND	5 D.DN		6 D.UP	MODE

PWR

MONO

LOC

ILL

BAND

CHANNEL

NUMBER

CATEGORY/GENRE

Typical Channel Display

NOTE: If program reception is noisy or contains audible back- ground static, switch your radio to another FM frequency. Refer to Direct FM Frequency Selection later in this manual for details on how to select another FM

Typical Car Radio

3.At the Satellite Control Unit (SCU), momentarily press the

Power On/Off button ( ); the Audiovox logo appears and then slowly fades out. This may be followed by the LOADING message on the display. This display indicates that the system is acquiring and loading the satellite information.

frequency.

SELECTING A SATELLITE CHANNEL

Asatellite channel can be selected in three ways; namely, by scrolling station-by-station, by selecting a group or category or by direct access.

5

128-6210

5 of 12