Remote connection, Power connection | Extron electronic SW RGB

Remote connection

7Remote connector — Connect a host device, such as a computer or touch panel control, or a remote contact closure device to the switcher via this 9-pin D connector (figure 2-11) for remote control of the switcher.

See chapter 4, Remote Control, for definitions of the SIS commands, details on how to install and use the control software, and information on how to make a remote contact closure device.

5		1	Pin	RS-232	Contact closure	Function
			1	—	In #1	Input #1

			2	TX	—	Transmit data (-)
9	6		3	RX	—	Receive data (+)
Female
			4	—	In #2	Input #2
1		5
			5	Gnd	Gnd	Signal ground

			6	—	In #3	Input #3
6	9		7	—	In #4	Input #4
	Male		8	—	In #5	Input #5

			9	—	In #6	Input #6

Figure 2-11 — Remote port connector and pinout

Power connection

8AC power connector — Plug a standard IEC power cord into this connector to connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.

SW RGB and YUV A Switchers • Installation 2-9

Image 19

Extron electronic SW RGB, SW YUV A manual Remote connection, Power connection

Contents

SW RGB and SW YUV a Series Wideband and Component Video and Audio Switchers Instrucciones de seguridad Español Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen Deutsch SW RGB and YUV a Switchers Quick Start QS-1 Quick Start SW RGB and YUV a Switchers QS-2 SW RGB and YUV a Switchers Quick Start Quick Start SW RGB and YUV a Switchers, cont’dSwitch mode Switch inputs in normal switch mode Table of Contents Table of Contents, cont’d One SW RGB and YUV a Switchers Introduction About the SwitchersIntroductiontroduction, cont’d RGB video models FeaturesAudio switching models All switchers All models Introduction, cont’d Two Rack mounting the switcher Installationstallation, cont’dInstallation Overview Mounting the Switcher Rack mounting an SW2 switcher Under furniture mounting the switcher Installation, cont’d Through-desk mounting Through furniture mounting the switcher Cabling and Rear Panel Views SW2 Rgbhv video switcher RGB and component video inputs Inputs RGB and component video outputs Output Remote connection Power connection Installation, cont’d Three Operationeration, cont’d Controls and IndicatorsInput selection controls and indicators SW RGB and YUV a Switchers Operation Autoswitch mode control and indicator Audio controls and indicators Operation, cont’d Switcher OperationsPower Switching inputs Example Viewing the audio level Example Adjusting the audio level Example, step D Adjusting the audio level Memory Audio level reset single inputAudio level reset all inputs Optimizing the Audio SW2, SW4, and SW6 Rgbhv a only Troubleshooting If No Image Appears Four Simple Instruction Set Host-to-switcher instructionsSW RGB and YUV a Switchers Remote Control RemoteControl,cont’d Using the command/response table Switcher-initiated unsolicited messagesError responses Timeout Symbol definitions Remote Control, cont’dCommand Ascii Command Response Additional description Reset Using the software Installing the softwareWindows-Based Control Program Using the help system Infrared Remote ControlContact Closure Remote Control, cont’d AAppendix a Specifications and Part Numbers SW RGB and YUV a Switchers Specifications and Part Numbers Specificationsecifications, cont’d Sync Audio output SW 2/4/6 Rgbhv a only Specifications, cont’d Part Numbers SW Rgbhv switcher part numbersSupplied accessories Optional accessories Pre-cut cables Assorted connectors BNC connectorsPlenum BNC-5 Mini HR Cable BNC-5 RC and BNC-6 RC Cable FCC Class a Notice Extron’s Warranty Extron Electronics, USA