Using the help system

For information about program features, you can access the help program in any of the following ways:

From the Extron Electronics program group, double-click on the Universal Switcher Control Program Help icon.

From within the Windows-based switcher control program, click on the Help entry on the task bar.

From within the Windows-based switcher control program, press the F1 key.

Contact Closure

The Remote connector also provides a way to select an input to the switcher by using a remote contact closure device, such an Extron KP 6 Keypad Remote Control or a locally-built device. Contact closure control uses pins on the Remote connector that are not used by the RS-232 interface. The contact closure pin assignments are shown in the table on page 4-2.

Autoswitching models must be in normal (manual) mode.

To select a different input number using a contact closure device, momentarily short the pin for the desired input number to logic ground (pin 5). To force one of the inputs to be always selected, leave the short to logic ground in place. The short overrides front panel input selections.

Infrared Remote Control

The optional Extron IR 102 Remote Control Kit consists of the following components:

IR 102 system remote (hand-held remote control)

IR detector with 6’ cable

IR 102 receiver box with 3’ cable

External 12 VDC adapter power supply

Install and operate the remote control in accordance with IR 102 User’s Guide (part #68-663-01) included with the remote.

SW RGB and YUV A Switchers • Remote Control 4-7

Page 35
Image 35
Extron electronic SW RGB, SW YUV A manual Contact Closure, Infrared Remote Control, Using the help system