Pioneer VSX-9300TX manual 09Using other functions, Switching the speaker impedance

Models: VSX-9300TX

1 100
Download 100 pages 34.99 Kb
Page 64
Image 64
09Using other functions

09Using other functions

Switching the speaker impedance

• Default setting: Speaker 8

You can use speakers with a nominal impedance between 6–16but if you are using speakers with an impedance of less than 8, you must change the impedance setting below.

• With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button.

Advanced remote control features

Switching the speaker impedance Note

You can cancel or exit any of the following steps by pressing REMOTE SETUP.

After one minute of inactivity, the remote goes to sleep. Press any button to reactivate the remote display and continue.

DVD/LD

TV/SAT

VCR1 /

TVCONT

DVR

MULTI CONTROL

 

VCR2

VIDEO

CD

 

CD-R/

MD/

TUNER

 

TAPE1

TAPE2

 

REMOTE

SETUP

ENTER

Editing remote control display names

Each time you do this, you switch between the impedance settings:

Speaker 6– Use this setting if your speakers are rated lower than 8(down to 6).

Speaker 8– Use this setting if your speakers are rated 8–16.

You can rename what appears in the display on the remote control for the MULTI CONTROL buttons (such as DVD/LD or TV/SAT), or for individual buttons for each input source. You may want to do this if the component connected to the inputs doesn’t correspond to the MULTI CONTROL button name, or individual commands don’t correspond to their respective buttons.

1Press and hold REMOTE SETUP for three seconds. The REMOTE SETUP menu appears in the remote control display.

2 Use (cursor up/down) to select ‘FuncName’ or ‘Key Label’ from the menu and press ENTER. Select Function Name (FuncName) if you want to rename a MULTI CONTROL button.

Select Key Label (KeyLabel) if you want to rename a command button (you can rename individual command buttons for each input source).

Select Function flashes in the display.

3 Press the MULTI CONTROL button for the component.

If you selected Function Name (FuncName) above, go to step 5.

If you selected Key Label (KeyLabel) above, Select Key flashes in the display.

64

En

Page 64
Image 64
Pioneer VSX-9300TX manual 09Using other functions, Switching the speaker impedance, Advanced remote control features