Extron electronic SW RGB, SW YUV A Through furniture mounting the switcher, Through-desk mounting

3.	Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
	desk at the marked screw locations from the underside/inside (concealed
	side) of the furniture, where the switcher will be located.
4.	Insert the four wood screws into the pilot holes. Fasten each screw into the
	installation surface until just less than 1/4" of the screw head protrudes.
5.	Align the installed screws with the slots in the mounting brackets, and place
	the switcher against the surface, with the screws through the bracket slots.
6.	Slide the switcher slightly forward or back, then tighten all four screws to
	fasten it in place.

Through furniture mounting the switcher

The switchers can be mounted through a desk or other furniture. The SW2 models require an optional through-desk mounting kit, part #70-077-02. The SW4 and SW6 models require the included through-desk and rack mounting bracket. Mount the switcher through a desk or table as follows (figure 2-4):

Figure 2-4 — Through-desk mounting

1.	Loosely attach the mounting brackets to the switcher using the four machine screws and
	washers supplied with the mounting kit. On the SW4 and SW 6 models, use two screws on
	each side of the switcher, inserted through the adjustable (slotted) holes on the brackets
	(figure 2-2).
2.	Hold the switcher against the underside of the surface through which it will be mounted.
	Mark the four screw holes on the underside of the surface to which you are mounting the
	device.
3.	Drill four pilot holes, each 3/32" in diameter by 1/4" deep, where you made marks.
4.	Using the four wood screws provided, attach the brackets to the mounting surface.

SW RGB and YUV A Switchers • Installation 2-5