Jenn-Air W10379134A manual Install Overlay Series Custom Panels, Door Panel Installation

Page 20

1.Use a ⁵⁄₁₆" socket driver to turn the leveling bolts clockwise to extend the legs to the floor as shown. The rollers should be off the floor.

■Jenn-Air is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service.

A B

A

B

A. Rear leveling bolt

B. Front leveling bolt

2.Adjust the leveling legs to level and align the refrigerator from left to right and front to back so that the refrigerator is level and aligned with the cabinetry. The cabinetry surface must be plumb for the ideal fit of the refrigerator side trim.

3.Continue adjusting all of the leveling legs to raise the refrigerator until the top is within at least 1" (2.54 cm) of the top soffit.

NOTE: If an anti-tip board has been used, adjust the leveling legs until the top of the refrigerator is within ¹⁄₄" (6.35 mm) of the bottom of the anti-tip board as shown. Do not crush the compressor cover.

A B

C

¹⁄₄" (6 mm) max.

2" (5 cm)

D

A. Center board ¹⁄₄" (6.35 mm) max. above refrigerator

B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards

C. Attach to studs with six #8 x 3" (7.6 cm) screws

D. Compressor cover

IMPORTANT: Adjust in small increments to keep from damaging the cabinet trim and causing problems with the door alignment or top grille fit. To avoid damage to the cabinet or leveling legs, do not apply more than 50 inch-pounds

(5.65 Nm) of torque to the leveling bolts. The leveling legs can be extended to a maximum of 1¹⁄₄" (3.18 cm) below the rollers.

4.For Classic and Overlay models, additional adjustments may be needed after the custom panels are installed.

Install Overlay Series Custom Panels

IMPORTANT:

■Install the custom handles prior to installing the panels on the refrigerator. For more information on Jenn-Air custom handle selection, refer to the Jenn-Air Catalog, visit www.jennair.com, or call 1-800-JENNAIR(1-800-536-6247). In Canada, visit www.jennair.ca, or call 1-800-807-6777.

■Create custom door overlay panels according to the specifications in the “Overlay Series Custom Panels” section.

Door Panel Installation

1.Remove all tape and door bracing from the refrigerator and freezer doors.

2.Open the refrigerator and freezer compartment doors.

3.Remove the handle side and top trims.

AA

A.Trims

4.Slide the custom panels into the bottom and hinge side trims on the refrigerator compartment and freezer compartment doors, making sure that the backer panel fits into the hinge side trims.

AA

A.Panels

5.Reinstall the handle-side and top trims.

6.Remove the skin from the screw covers. Slide or snap the screw covers into the handle trim section.

7.Check refrigerator level and alignment. Adjust if needed.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Installation Guide Guide D’INSTALLATIONTable of Contents/Índice/Table des matières Guiía DE InstalaciónTable DES Matières Table of ContentsÍndice Refrigerator Safety Your safety and the safety of others are very importantModels Non-Dispensing RefrigeratorsEuro-Style Design Overlay DesignDispensing Refrigerators Installation Requirements Opening DimensionsTools and Parts Location RequirementsRecommended Grounding Method Model Width a as shown above Dimension B As shown AboveElectrical Requirements Water Supply Requirements Tipping RadiusWater Pressure Reverse Osmosis Water SupplyTop View Product DimensionsSide View Door Swing Dimensions 42 106.7 cm ModelsFront View 48 121.9 cm ModelsOverlay Panel Overlay Series Door Panel and Cabinetry Clearance90˚ Door Stop Position Hinge Represents placement of dispenser overlay Overlay Series Custom Panels and Handle KitsDecorative Overlay Panel ModelRefrigerator and Side Trim Dimensions Euro-Style and Pro-Style Custom Side PanelsBacker Panels Dispenser Frame dispenser models onlyOverlay Series Custom Side Panels Unpack the Refrigerator Reduce Tipping RadiusMeasure the distance from point a as shown to back wall Model Reduced Tipping RadiusMove the Refrigerator into House Install Anti-Tip BoardsTo Install Anti-tip Boards Connect the Water Supply Connect to Water Line Parts NeededStyle 1 Shutoff Valve Connection Parts SuppliedLevel and Align Refrigerator Move Refrigerator to Final LocationPlug in Refrigerator Install Overlay Series Custom Panels Door Panel InstallationAdjust Doors Door Height AdjustmentTop Grille Panel Euro-Style and Pro-StyleStylesInstall Base Grille Install Side PanelDoor Swing Adjustment Door-to-Door or Door-to-Refrigerator Trim AdjustmentComplete Installation Water System PreparationStyle 1 Dispenser Models Style 2 Non-Dispenser ModelsSeguridad DEL Refrigerador Su seguridad y la seguridad de los demás es muy importanteModelos Refrigeradores sin despachadorDiseño Euro-Style Diseño OverlayRefrigeradores con despachador Requisitos DE Instalación Piezas y herramientasRequisitos de ubicación Medidas de la aberturaRequisitos eléctricos Método de conexión a tierra recomendadoRequisitos del suministro de agua Arco de vuelcoPresión del agua Suministro de agua de ósmosis inversaVista superior Medidas del productoVista lateral Medidas de oscilación de las puertas Modelos de 42 106,7 cmVista frontal Modelos de 48 121,9 cmPuerta Panel de Modelo Paneles a la medida y juegos de manijas de la serie OverlayPanel decorativo con revestimiento El marco del despachador se sujeta al panel con 4 tornillos Paneles de soporteMarco del despachador Solamente en modelos con despachador Paneles laterales a la medida Euro-Style y Pro-Style Paneles laterales a la medida para la Serie OverlayMedidas para la instalación relieve empotrada Instrucciones DE InstalaciónDesempaque el refrigerador Cómo reducir el arco de vuelco Cómo hacer entrar el refrigerador En la casaCómo instalar los tableros antivuelco Modelo Arco de vuelco reducidoConexión del suministro de agua Cómo instalar los tableros antivuelcoConexión a la línea de agua Piezas necesarias Estilo 1 Conexión de la válvula de cierreCómo enchufar el refrigerador Conexión al refrigerador Piezas suministradasCómo mover el refrigerador a su Ubicación final Nivelación y alineamiento Del refrigeradorPanel de la rejilla superior Cómo instalar los paneles a la medida para la serie OverlayInstalación del panel de la puerta Ajuste las puertas Cómo ajustar la altura de la puertaCómo ajustar la oscilación de las puertas Estilo Euro y ProCómo instalar la rejilla de la base Cómo instalar el panel lateralCómo terminar la instalación Preparación del sistema de aguaEstilo 1 Modelos con despachador Estilo 2 Modelos sin despachadorSécurité DU Réfrigérateur Votre sécurité et celle des autres est très importanteModèles Réfrigérateurs sans distributeurModèle Euro-Style Modèle OverlayRéfrigérateurs avec distributeur Exigences D’INSTALLATION Exigences d’emplacementDimensions de l’ouverture Outillage et piècesMéthode recommandée de mise à la terre Spécifications électriquesSpécifications de l’alimentation en eau Rayon de basculementPression de leau Alimentation en eau par osmose inverseVue de dessus Dimensions du produitVue latérale Modèles de 48 121,9 cm Dimensions pour le pivotement Des portesModèles de 42 106,7 cm Vue avant Série Overlay Panneau de porte et placard espace libre Charnière PlacardPanneau Modèle Panneaux personnalisés et poignées de la série OverlayPanneau décoratif de recouvrement Panneaux dappui RemarquesPanneaux latéraux personnalisés de la Série Overlay Déballage du réfrigérateur Instructions ’INSTALLATIONDimensions dinstallation pour un panneau inséré en retrait Installation de planches antibasculement Réduction du rayon de basculementFaire entrer le réfrigérateur Dans le domicile Modèle Rayon de basculement réduitInstallation des planches antibasculement Raccordement à lalimentation en eauRaccordement à la canalisation deau Pièces nécessaires Style 1 Connexion avec robinet darrêtPièces fournies Brancher le réfrigérateurRaccordement au réfrigérateur Déplacement du réfrigérateur à Lemplacement final Réglage de laplomb et alignement Du réfrigérateurPanneau de la grille supérieure Installation des panneaux personnalisés de la Série OverlayInstallation des panneaux de porte Styles Euro et Pro-Style Ajustement des portesAjustement de la hauteur des portes Ajustement du pivotement des portes Installation du panneau latéralInstallation de la grille de la base Achever l’installation Préparation du système d’eauStyle 1 Modèles avec distributeur Emboîter la plinthe sur la grille de la baseStyle 2 Modèles sans distributeur W10379134A

W10379134A specifications

The Jenn-Air W10379134A is a high-performance kitchen appliance that exemplifies innovation and quality in home cooking. Designed for the discerning chef, it combines advanced technologies with stylish aesthetics, making it a standout choice for modern kitchens.

One of the primary features of the W10379134A is its versatile cooking capabilities. This appliance supports various cooking methods, allowing users to bake, broil, and roast with precision. Its multi-functionality caters to a wide array of culinary techniques, ensuring that home cooks can experiment and perfect their recipes.

The appliance includes a powerful convection fan that ensures even heat distribution throughout the cooking space. This technology is vital for achieving consistent cooking results, whether baking a delicate soufflé or roasting a whole chicken. With the convection feature, the Jenn-Air W10379134A enhances efficiency, significantly reducing cooking times while preserving moisture and flavor in foods.

Another significant characteristic of the Jenn-Air W10379134A is its intuitive control panel, which provides users with an easy interface. The digital display is user-friendly, allowing cooks to select from various temperature settings and cooking options with minimal effort. Furthermore, the appliance is designed with pre-programmed settings that simplify many cooking tasks, making it approachable for cooks of all experience levels.

In terms of design, the Jenn-Air W10379134A boasts a sleek, modern aesthetic that seamlessly integrates into any kitchen decor. Available in stainless steel or other finishes, its elegant look enhances the overall visual appeal of the kitchen. The quality of materials used ensures durability and longevity, making it a worthwhile investment for homeowners.

Safety is also paramount with the Jenn-Air W10379134A. It is equipped with features such as a temperature probe and automatic shut-off functions, which provide peace of mind during cooking. These safety mechanisms help prevent overcooking and promote energy efficiency, which is essential in today’s eco-conscious world.

In conclusion, the Jenn-Air W10379134A emerges as a powerful, versatile, and stylish addition to any kitchen. With its advanced features, user-friendly interface, and elegant design, it meets the needs of both seasoned chefs and novice cooks alike, promoting culinary creativity while ensuring optimal cooking results.
Top Page Image Contents