Jenn-Air W10379134A manual Install Base Grille, Install Side Panel, Door Swing Adjustment

Page 22

8.Make final recheck to make sure the doors are aligned and even.

Door Swing Adjustment

1.Check that the refrigerator door can open freely. If the door opens too wide, remove the door stop screw or screws (depending on your model) from the bottom hinge. See “Door Height Adjustment” earlier in this section.

2.Hold the door open to a position that is less than 90°.

3.Replace the door stop screw or screws in the bottom hinge and tighten.

A B C

A.130°

B.110° (Overlay series)

C.90°

Door-to-Door or Door-to-Refrigerator Trim Adjustment

1.Loosen, but do not remove, the four Torx®† 27 flat-head mounting screws and the two ¹⁄₄" hex-head mounting screws.

2.Adjust the top hinge of either door to align it with the other door or the refrigerator trim.

3.Tighten the four Torx®† 27 flat-head mounting screws to a torque of approximately 100 inch-pounds (11.3 Nm) and tighten the two ¹⁄₄" hex-head mounting screws.

A

B

A.Torx® 27 flat-head mounting screws

B.¹⁄₄" hex-head mounting screws

2.Nail the rear edge of the panel to the support board.

A

B

A. Support board (mounted to back wall)

B. Cab side trim

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: the base grille itself and the skirt. The skirt can be added to the base grille in order to extend it all the way to the floor.

1.To see whether the skirt is needed, place the base grille into position. Do not attach the base grille to the refrigerator. Measure the distance between the bottom of the base grille and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in order to add the skirt.

NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip steps 3 and 4 of the instructions, and install the base grille only.

2.Remove the film from the base grille.

3.Snap the skirt onto the base grille.

Install Side Panel

If the built-in area depth is 25" (63.5 cm) or more, the side panels

 

can be installed inside the side trim or attached to the outside of

 

the side trim.

A

IMPORTANT: Jenn-Air is not responsible for the removal or

 

addition of molding or decorative panels that would not allow

B

access to the refrigerator for service.

 

1.For the inside side trim piece, slide the front edge of the routed side panel into the trim piece.

A. Base grille

B. Skirt

†®TORX is a registered trademark of Saturn Fasteners, Inc.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Table of Contents/Índice/Table des matières Installation GuideGuide D’INSTALLATION Guiía DE InstalaciónÍndice Table of ContentsTable DES Matières Refrigerator Safety Your safety and the safety of others are very importantEuro-Style Design ModelsNon-Dispensing Refrigerators Overlay DesignDispensing Refrigerators Tools and Parts Installation RequirementsOpening Dimensions Location RequirementsElectrical Requirements Model Width a as shown above Dimension B As shown AboveRecommended Grounding Method Water Pressure Water Supply RequirementsTipping Radius Reverse Osmosis Water SupplySide View Product DimensionsTop View Front View Door Swing Dimensions42 106.7 cm Models 48 121.9 cm ModelsOverlay Panel Overlay Series Door Panel and Cabinetry Clearance90˚ Door Stop Position Hinge Decorative Overlay Panel Represents placement of dispenser overlayOverlay Series Custom Panels and Handle Kits ModelBacker Panels Refrigerator and Side Trim DimensionsEuro-Style and Pro-Style Custom Side Panels Dispenser Frame dispenser models onlyOverlay Series Custom Side Panels Measure the distance from point a as shown to back wall Unpack the RefrigeratorReduce Tipping Radius Model Reduced Tipping RadiusTo Install Anti-tip Boards Install Anti-Tip BoardsMove the Refrigerator into House Style 1 Shutoff Valve Connection Connect the Water SupplyConnect to Water Line Parts Needed Parts SuppliedPlug in Refrigerator Move Refrigerator to Final LocationLevel and Align Refrigerator Install Overlay Series Custom Panels Door Panel InstallationTop Grille Panel Adjust DoorsDoor Height Adjustment Euro-Style and Pro-StyleStylesDoor Swing Adjustment Install Base GrilleInstall Side Panel Door-to-Door or Door-to-Refrigerator Trim AdjustmentStyle 1 Dispenser Models Complete InstallationWater System Preparation Style 2 Non-Dispenser ModelsSeguridad DEL Refrigerador Su seguridad y la seguridad de los demás es muy importanteDiseño Euro-Style ModelosRefrigeradores sin despachador Diseño OverlayRefrigeradores con despachador Requisitos de ubicación Requisitos DE InstalaciónPiezas y herramientas Medidas de la aberturaRequisitos eléctricos Método de conexión a tierra recomendadoPresión del agua Requisitos del suministro de aguaArco de vuelco Suministro de agua de ósmosis inversaVista lateral Medidas del productoVista superior Vista frontal Medidas de oscilación de las puertasModelos de 42 106,7 cm Modelos de 48 121,9 cmPuerta Panel de Panel decorativo con revestimiento Paneles a la medida y juegos de manijas de la serie OverlayModelo Marco del despachador Solamente en modelos con despachador Paneles de soporteEl marco del despachador se sujeta al panel con 4 tornillos Paneles laterales a la medida Euro-Style y Pro-Style Paneles laterales a la medida para la Serie OverlayDesempaque el refrigerador Instrucciones DE InstalaciónMedidas para la instalación relieve empotrada Cómo instalar los tableros antivuelco Cómo reducir el arco de vuelcoCómo hacer entrar el refrigerador En la casa Modelo Arco de vuelco reducidoConexión a la línea de agua Piezas necesarias Conexión del suministro de aguaCómo instalar los tableros antivuelco Estilo 1 Conexión de la válvula de cierreCómo enchufar el refrigerador Conexión al refrigerador Piezas suministradasCómo mover el refrigerador a su Ubicación final Nivelación y alineamiento Del refrigeradorInstalación del panel de la puerta Cómo instalar los paneles a la medida para la serie OverlayPanel de la rejilla superior Cómo ajustar la oscilación de las puertas Ajuste las puertasCómo ajustar la altura de la puerta Estilo Euro y ProCómo instalar la rejilla de la base Cómo instalar el panel lateralEstilo 1 Modelos con despachador Cómo terminar la instalaciónPreparación del sistema de agua Estilo 2 Modelos sin despachadorSécurité DU Réfrigérateur Votre sécurité et celle des autres est très importanteModèle Euro-Style ModèlesRéfrigérateurs sans distributeur Modèle OverlayRéfrigérateurs avec distributeur Dimensions de l’ouverture Exigences D’INSTALLATIONExigences d’emplacement Outillage et piècesMéthode recommandée de mise à la terre Spécifications électriquesPression de leau Spécifications de l’alimentation en eauRayon de basculement Alimentation en eau par osmose inverseVue latérale Dimensions du produitVue de dessus Modèles de 42 106,7 cm Vue avant Dimensions pour le pivotement Des portesModèles de 48 121,9 cm Série Overlay Panneau de porte et placard espace libre Charnière PlacardPanneau Panneau décoratif de recouvrement Panneaux personnalisés et poignées de la série OverlayModèle Panneaux dappui RemarquesPanneaux latéraux personnalisés de la Série Overlay Dimensions dinstallation pour un panneau inséré en retrait Instructions ’INSTALLATIONDéballage du réfrigérateur Faire entrer le réfrigérateur Dans le domicile Installation de planches antibasculementRéduction du rayon de basculement Modèle Rayon de basculement réduitRaccordement à la canalisation deau Pièces nécessaires Installation des planches antibasculementRaccordement à lalimentation en eau Style 1 Connexion avec robinet darrêtRaccordement au réfrigérateur Brancher le réfrigérateurPièces fournies Déplacement du réfrigérateur à Lemplacement final Réglage de laplomb et alignement Du réfrigérateurInstallation des panneaux de porte Installation des panneaux personnalisés de la Série OverlayPanneau de la grille supérieure Ajustement de la hauteur des portes Ajustement des portesStyles Euro et Pro-Style Installation de la grille de la base Installation du panneau latéralAjustement du pivotement des portes Style 1 Modèles avec distributeur Achever l’installationPréparation du système d’eau Emboîter la plinthe sur la grille de la baseStyle 2 Modèles sans distributeur W10379134A

W10379134A specifications

The Jenn-Air W10379134A is a high-performance kitchen appliance that exemplifies innovation and quality in home cooking. Designed for the discerning chef, it combines advanced technologies with stylish aesthetics, making it a standout choice for modern kitchens.

One of the primary features of the W10379134A is its versatile cooking capabilities. This appliance supports various cooking methods, allowing users to bake, broil, and roast with precision. Its multi-functionality caters to a wide array of culinary techniques, ensuring that home cooks can experiment and perfect their recipes.

The appliance includes a powerful convection fan that ensures even heat distribution throughout the cooking space. This technology is vital for achieving consistent cooking results, whether baking a delicate soufflé or roasting a whole chicken. With the convection feature, the Jenn-Air W10379134A enhances efficiency, significantly reducing cooking times while preserving moisture and flavor in foods.

Another significant characteristic of the Jenn-Air W10379134A is its intuitive control panel, which provides users with an easy interface. The digital display is user-friendly, allowing cooks to select from various temperature settings and cooking options with minimal effort. Furthermore, the appliance is designed with pre-programmed settings that simplify many cooking tasks, making it approachable for cooks of all experience levels.

In terms of design, the Jenn-Air W10379134A boasts a sleek, modern aesthetic that seamlessly integrates into any kitchen decor. Available in stainless steel or other finishes, its elegant look enhances the overall visual appeal of the kitchen. The quality of materials used ensures durability and longevity, making it a worthwhile investment for homeowners.

Safety is also paramount with the Jenn-Air W10379134A. It is equipped with features such as a temperature probe and automatic shut-off functions, which provide peace of mind during cooking. These safety mechanisms help prevent overcooking and promote energy efficiency, which is essential in today’s eco-conscious world.

In conclusion, the Jenn-Air W10379134A emerges as a powerful, versatile, and stylish addition to any kitchen. With its advanced features, user-friendly interface, and elegant design, it meets the needs of both seasoned chefs and novice cooks alike, promoting culinary creativity while ensuring optimal cooking results.
Top Page Image Contents