Jenn-Air W10394575A Electrical Requirements, Gas Supply Requirements, Type of Gas, Natural Gas

Page 6

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided.

■Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded.

■The wiring diagram is located behind the kick plate in a clear plastic bag.

Gas Supply Requirements

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1/NFPA 54 - latest edition or CAN/CGA B149 - latest edition.

IMPORTANT: Range must be connected to a regulated gas supply.

IMPORTANT: Leak testing of the range must be conducted according to the manufacturer’s instructions.

Type of Gas

Natural Gas:

This range is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas.

■This range is factory set for use with Natural gas. The model/ serial rating plate located under the console on the right-hand side has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier.

LP Gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the range from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. To convert to LP gas, use the LP gas conversion kit provided with your range and see the “Gas Conversions” section. The parts for this kit are in the literature package supplied with the range.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Installation Instructions Range Safety Your safety and the safety of others are very importantInstallation Requirements Tools and PartsMobile home installations require Mobile Home Additional Installation RequirementsProduct Dimensions 30 76.2 cm models Location RequirementsCabinet Dimensions 48 121.9 cm modelsType of Gas Electrical RequirementsGas Supply Requirements Natural GasGas Pressure Regulator Gas Supply Pressure TestingGas Supply Line Burner Input Rating AltitudeUnpack Range Installation InstructionsInstall Anti-Tip Bracket Measurement BMake Gas Connection Floor MountingWall Mounting Level Range Install GriddleVerify Anti-Tip Bracket Location Complete ConnectionElectronic Ignition System If you need Assistance or Service Reinstall Kick PlateComplete Installation Check Operation of Oven Bake BurnersGAS Conversions LP Gas ConversionTo Convert Gas Pressure Regulator Gas Supply Pressure Testing Pull electrode out of bracket Replace Oven Bake Burner Cover ABBAB C Pull electrode out of bracket To Convert Surface Burners Burner orifice spudComplete Installation Natural Gas Conversion Line pressure testing above ½ psi gauge 14 WCP Pull electrode out of bracket Replace Oven Bake Burner Cover AB C Pull electrode out of bracket 000 BTU 01 mm Small burners 15,000 BTU 75 mm Wiring Diagrams Atlas48 121.9 cm Oven Schematic for JGRP548 Model User Interface UI HMI KeyboardBurner Cooktop Schematic Strip CircuitsSW1 Sécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteExigences Dinstallation Outils et piècesExigences d’emplacement Dimensions du produit Modèles de 30 76,2 cmModèles de 36 91,4 cm Dimensions du placard Revêtement de hotte au-dessus de la cuisinière, suivre lesSpécifications électriques Spécifications de lalimentation en gazType de gaz Débit thermique des brûleurs Altitude Canalisation de gazDétendeur Test de pressurisation de la canalisation de gazDéballage de la cuisinière Instructions D’INSTALLATIONInstallation de la bride antibasculement Mesure BRaccordement au gaz Montage au plancherMontage au mur Réglage de laplomb de la cuisinière Vérification de lemplacement de la bride AntibasculementInstallation de la plaque à frire Achever le raccordementSystème dallumage électronique Réinstallation du garde-pieds Réinstaller les vis au sommet du garde-piedsAchever l’installation Conversions Pour Changement DE GAZConversion pour lalimentation au propane Conversion du détendeur Test de pressurisation de la canalisation de gazCouvercle du brûleur de cuisson au four Dégager lélectrode du support Réinstaller le couvercle du brûleur de cuisson au four AB C Dégager lélectrode du support Conversion des brûleurs de surface Gicleur de brûleurAchever l’installation Conversion pour lalimentation au gaz naturel Déflecteur du four Écrous du déflecteur du four Lame plate puis retirer lélectrode Réinstaller le couvercle du brûleur de cuisson au four AB C Dégager lélectrode du support Réinstaller le couvercle du brûleur de cuisson au four 15 000 BTU 75 mm Schémas de câblage RemarquesSchéma du four de 48 121,9 cm pour modèle JGRP548 Interface Utilisateur IUSchémas des circuits Schéma de la table de cuisson à 4 brûleursSW2 Schéma de la table de cuisson à 6 brûleursW10394575A

W10394575A specifications

The Jenn-Air W10394575A is a premium kitchen appliance that embodies the fusion of design, functionality, and cutting-edge technology, elevating the cooking experience for culinary enthusiasts and home chefs alike. This product is designed to offer superior performance while enhancing the aesthetic appeal of modern kitchen spaces.

One of the standout features of the Jenn-Air W10394575A is its high-efficiency performance, which is driven by innovative technology that ensures consistent heating and cooking results. The appliance is equipped with powerful heating elements that provide quick responsiveness, reducing overall cooking time. With its precise temperature control, users can expect impeccable results in every dish, from delicate pastries to hearty casseroles.

A key characteristic of the Jenn-Air W10394575A is its elegant design, tailored to fit seamlessly into contemporary kitchen interiors. The sleek lines and high-quality materials used in its construction not only create a visually stunning appliance but also ensure durability and long-term reliability. The surface is designed for easy cleaning, allowing users to maintain its pristine appearance with minimal effort.

In addition to its aesthetic appeal, the Jenn-Air W10394575A also incorporates user-friendly features that enhance the cooking experience. Its intuitive interface includes a digital display and straightforward controls, making it easy for users to select their desired settings. The appliance offers multiple cooking modes, catering to various culinary techniques such as baking, broiling, and warming, which provides versatility for different cooking styles.

Safety is another priority in the design of the Jenn-Air W10394575A. The appliance comes equipped with advanced safety features, including automatic shut-off and cool-touch surfaces, ensuring a secure cooking environment. This attention to safety allows users—regardless of expertise—to cook with confidence.

Overall, the Jenn-Air W10394575A is a remarkable addition to any kitchen, combining stylish design, advanced technology, and practical features. It is ideal for anyone who appreciates quality and performance, transforming everyday cooking into a refined culinary experience. Whether you're preparing a casual family meal or hosting a dinner party, this appliance is designed to meet and exceed the needs of modern homeowners.
Top Page Image Contents