Jenn-Air JGD8348BDP dimensions ConnectingAppliance To Gas Supply, Air Shutter Adjustment

Page 5

ConnectingAppliance To Gas Supply

A TRAINED SERVICEMAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY

CONNECTION. Leak testing of the appliance shall be conducted by the installer according to the instructions given.

Install a manual shutoffvalve in an accessible locationin

the gas line external to thisappliance for the purpose of turning on or shuttingoff gas to the appliance.

Make the gas connectionto the inlet of the appliance

pressure regulatoron this appliancewith a 1/2" male pipe thread. Use an approvedpipe joint compoundresistantto the actionof LP gas at pipeconnections.Test all joints for gas leaks with a soap and water solutionor other

accepted leak detectionmeans. Never test for gas leaks with an openflame,

Air Shutter Adjustment

This appliance is shipped from the factory with air shutters adjusted for use with Natural Gas. If further adjustment is

necessary, or to reset for usewith LP, adjust air shutters as follows:

Grill Burner and Surface Burner

Cartridge Air Shutters

(See///ustrations "A" & "B')

The left hand air shuttercontrolsthe rear half of the burner. The fight handshutter controlsthe front half. Access to air

shutters on the surface burner cartridge may be found throughopeningson the bottomof the cartridge housing. Slide air shutters backward or forward to increase or

decrease the size of the air opening.Air shuttersfit snugly, soa screwdriverblade or needlenosepliersmay be required to make this adjustment(see illustration).

Observe change in flame appearance as the air shutter is moved. Adjustmentis satisfactory when a clearly defined, even blue flame resultsat the high flame setting. The snug fit of theairshutterassurasit willremainpositionedcorrectly.

IGrill Burner Air Shutter and Surface Burner

(if so equipped)

AIRSHU'CrER /

_--INSERTSCREWDRIVER BLADEINSLOTANDTWIST WITHSLIGHTPRESSURETO

ALLOWAIRSHUTTERTO SLIDEEASILY

Illustration ",4"

On any burner, closing the air shutter too far will cause the flame to become soft and yellow tipped. Opening the air shutter too wide will cause the flame to blow away from the burnerports. Proper adjustmentwill produce a sharp, clearly defined, even blue flame.

Illustration "B" _'-_--J"

Image 5
Contents Triple Bay Conventional Gas JENN-AIF ProstyleTM Grill CooktopCabinet and Countertopcutouts ViewCabinetsAbove Cooking Top InstallingCabinetry Over Your Jenn-Air Grill38om Gure2 Main top, prior t o rem oving the control panel InstallationOf Appliance= ,,l Grill Burner and Surface Burner Cartridge Air Shutters ConnectingAppliance To Gas SupplyAir Shutter Adjustment Pressure Testing Important Installation SuggestionsLow Flame Adjustment ConversionIllustration E Control SettingsConversion To LP Gas #66 To ConvertapplianceforusewithpropanegasModel- JGD8348BDP PropaneGasLPTo NaturalGasProstyle Cooktop Minimumspacingrequirement GasgrillcooktopsTest the ventilation system for proper installation Requiredadjustmentsattimeofinstallation