Installation Instructions

?Before Using Your Appliance

?Remove the exterior and interior packing.

?Check to be sure you have all of the following parts:

?1 Bake/Broil/Drip Pan

?1 Metal Handling Tool

?1 Oven Wire Rack

?1 Rotisserie Skewer Handling Tool

?2 Rotisserie Meat Forks with screws

?1 Rotisserie Skewer

?1 Instruction Manual

?Remove all the items inside your oven and clean the interior surface with lukewarm water using a soft cloth.

?Do not attempt to repair or replace any part of your oven unless it is specially recommended in this manual.

?This appliance requires 1500W and should be the only appliance operating on the same circuit.

NOTICE

Before you use this oven for the first time: The heating elements have a protective coating, which must be burned off before use. To do this, open the oven door and set the temperature control knob to 250°C/480°F. Move the function selector to toast and rotate the timer control knob to approximately 15 minutes. It is important to ensure adequate ventilation during this period.

The dual burners also have a protective coating, which must be burned off before use. To do this, set the burner selector to the maximum setting 5 minutes. It is important to ensure adequate ventilation. Switch off the burners and allow cooling completely.

?Installation of Your Appliance

Select a location for the appliance. The location should be in an open area on a flat counter where

the plug will reach an outlet.

?When positioning the appliance, it should be set on a flat, steady surface.

?Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause the appliance failure.

?Keep the appliance away from hot air, steam or splashing liquids when choosing a place to locate it, otherwise, the unit’s operation may be adversely affected, causing it to break down.

?Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.

?Plug the appliance into an exclusive properly installed grounded wall outlet. Any questions concerning power should be directed toward a certified electrician or an authorized Avanti Products service center.

?Do not place anything on the top of the unit.

?Keep the appliance at least 5 inches away from rear wall to ensure the proper ventilation.