Operation, Start-Up | Bloomfield 8540, 8541, 8542, 8573, 8543, 8571

OPERATION

Fig. 4 Brewer Operation Diagram

IMPORTANT:

Tank must be full of water before connecting brewer to electrical power.

Heating elements will be damaged if allowed to operate without being fully submerged in water. Damage caused by operating the brewer without water in the tank is NOT COVERED BY WARRANTY.

A.START-UP

For initial start-up, or if the brewer has not been used for an extended period of time:

♦Be sure spray disk and brew gasket are properly installed in the brew head.

♦Be sure the water supply is properly connected and the water supply valve is turned ON.

♦Be sure the WATER TANK IS FILLED

BEFORE plugging the brewer into a receptacle, or otherwise connecting brewer to electrical power THE WATER TANK MUST BE FILLED. Place an empty decanter under the brew head. Lift the pour-over cover then pour warm tap water into the pour-over opening until water flows from the brew head. When water stops dripping from the brew head, empty the container.

Once the tank is full of water, connect the brewer to electrical power. The heating elements will begin heating the water in the tank. When the water has reached the proper temperature, the “HEAT” light will go out.