1.Select GPS/DATA, then SETTING.
2.Select TIME FORMAT.
3.Select 12 Hr or 24 Hr as desired. In this example, 12 hour format has been selected and so the LCD shows the AM or PM suffix.
2-5-4 Time Display Options (TIME DISPLAY)
If you have entered the time manually as described in the previous sections, the time is always shown on the screen with the prefix M.
However, if the vessel position is being updated through a GPS navigation receiver, you can switch the time display on the screen ON or OFF as follows:
SETTING TIME OFFSET TIME FORMAT >TIME DISPLY
TIME DISPLY ON >OFF
1.Select GPS/DATA, then SETTING.
2.Select TIME DISPLAY.
3.Select ON (on) or OFF (off ) as desired. In this example, OFF has been selected and so the screen no longer shows the time.
If the time display is set ON, course and speed data are not displayed on the LCD (see section
2-5-5 Position Display Options (LL display)
If you have entered the vessel position manually as described in the previous section, the vessel position is always shown on the screen with the suffix M.
However, if the time is being updated through a GPS navigation receiver, you can switch the vessel position display on the screen on or off as follows:
SETTING TIME FORMAT TIME DISPLY >LL DISPLAY
LLDISPLAY ON
>OFF
1.Select GPS/DATA, then SETTING.
2.Select LL DISPLAY.
3.Select ON (on) or OFF (off ) as desired. In this example, OFF has been selected and the screen no longer shows the vessel position.
2-5-6 Course & Speed Display Options (COG/SOG)
Use this option to display course over ground (COG) and speed over ground (SOG) data on
the screen.
SETTING TIME DISPLY
LLDISPLY >COG/SOG
COG/SOG
>ON
OFF
1.Select GPS/DATA, then SETTING.
2.Select COG/SOG.
3.Select ON (on) or OFF (off ) as desired. In this example, ON has been selected and so the screen shows the bearing and speed.
If COG/SOG is set ON (on), the time is not displayed on the screen (see section
Lowrance - | 25 |